EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Experimental Investigation of Magnetic Abrasive Finishing for Post-Processing Additive Manufactured Inconel 939 Parts

Michał Marczak, Dorota A. Moszczyńska, Aleksander P. Wawrzyszcz

Applied Sciences · 24.07.2025 · 15 (15) · 8233

DOI: 10.3390/app15158233 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 24.07.2025. Verfasst von Michał Marczak und 2 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study explores the efficacy of magnetic abrasive finishing (MAF) with planetary kinematics for post-processing Inconel 939 components fabricated by laser powder bed fusion (LPBF). Given the critical limitations in surface quality of LPBF-produced parts—especially in hard-to-machine superalloys like Inconel 939—there is a pressing need for advanced, adaptable finishing techniques that can operate effectively on complex geometries. This research focuses on optimizing the process parameters—eccentricity, rotational speed, and machining time—to enhance surface integrity following preliminary vibratory machining. Custom-designed samples underwent sequential machining, including heat treatment and 4 h vibratory machining, before MAF was applied under controlled conditions using ferromagnetic Fe-Si abrasives. Surface roughness measurements demonstrated a significant reduction, achieving Ra values from 1.21 µm to below 0.8 µm in optimal conditions, representing more than a fivefold improvement compared to the as-printed state (5.6 µm). Scanning Electron Microscopy (SEM) revealed progressive surface refinement, with MAF effectively removing adhered particles left by prior processing. Statistical analysis confirmed the dominant influence of eccentricity on the surface profile parameters, particularly Rz. The findings validate the viability of MAF as a precise, controllable, and complementary finishing method for LPBF-manufactured Inconel 939 components, especially for geometrically complex or hard-to-reach surfaces.

Zitieren

APA

Marczak, M., Moszczyńska, D. A., & Wawrzyszcz, A. P. (2025). Experimental Investigation of Magnetic Abrasive Finishing for Post-Processing Additive Manufactured Inconel 939 Parts. Applied Sciences, 15(15), 8233. https://doi.org/10.3390/app15158233

Vancouver

Marczak M, Moszczyńska DA, Wawrzyszcz AP. Experimental Investigation of Magnetic Abrasive Finishing for Post-Processing Additive Manufactured Inconel 939 Parts. Applied Sciences. 2025;15(15):8233. doi:10.3390/app15158233

BibTeX
@article{Marczak2025,
  author = {Marczak, Michał and Moszczyńska, Dorota A. and Wawrzyszcz, Aleksander P.},
  title = {Experimental Investigation of Magnetic Abrasive Finishing for Post-Processing Additive Manufactured Inconel 939 Parts},
  journal = {Applied Sciences},
  year = {2025},
  volume = {15},
  number = {15},
  pages = {8233},
  doi = {10.3390/app15158233}
}
Kostenlos starten →