EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Influence of Slag/Fly Ash as Partial Cement Replacement on Printability and Mechanical Properties of 3D-Printed Concrete

Kuo-Chang Tseng, Maochieh Chi, Weichung Yeih, Ran Huang

Applied Sciences · 03.04.2025 · 15 (7) · 3933

DOI: 10.3390/app15073933 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 03.04.2025. Verfasst von Kuo-Chang Tseng und 3 weiteren Autor:innen. Die Arbeit wurde bisher 22-mal zitiert (Crossref) und nennt 55 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministry of Science and Technology.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Three-dimensional printing is an emerging technique that has received significant attention in the construction industry. This study presents an investigation into the printing and hardened properties of 3D-printed concrete (3DPC). Both fly ash (FA) and ground granulated blast furnace slag (GGBFS) were used to replace cement in different ratios (0%, 25%, and 50%) to produce 3DPC. Extrudability and buildability tests were performed to evaluate the effects of FA and GGBFS in various proportions on the printing properties of 3DPC. Additionally, the hardened properties of 3DPC were determined. Test results show that all mix designs meet the printing requirements of 3DPC. The specimens with a higher proportion of GGBFS exhibited higher unit weight and compressive and flexural strength, but lower water absorption and drying shrinkage. The compressive and flexural strength of 3DPC in the printing direction were the highest, outperforming those of the cast specimens at the age of 28 days. Our results indicate that FA and GGBFS can be used to replace 50% of the cement in 3DPC.

Förderung

  • Ministry of Science and Technology

Zitieren

APA

Tseng, K., Chi, M., Yeih, W., & Huang, R. (2025). Influence of Slag/Fly Ash as Partial Cement Replacement on Printability and Mechanical Properties of 3D-Printed Concrete. Applied Sciences, 15(7), 3933. https://doi.org/10.3390/app15073933

Vancouver

Tseng K, Chi M, Yeih W, Huang R. Influence of Slag/Fly Ash as Partial Cement Replacement on Printability and Mechanical Properties of 3D-Printed Concrete. Applied Sciences. 2025;15(7):3933. doi:10.3390/app15073933

BibTeX
@article{Tseng2025,
  author = {Tseng, Kuo-Chang and Chi, Maochieh and Yeih, Weichung and Huang, Ran},
  title = {Influence of Slag/Fly Ash as Partial Cement Replacement on Printability and Mechanical Properties of 3D-Printed Concrete},
  journal = {Applied Sciences},
  year = {2025},
  volume = {15},
  number = {7},
  pages = {3933},
  doi = {10.3390/app15073933}
}
Kostenlos starten →