Error Modeling and Parameter Calibration Method for Industrial Robots Based on 6-DOF Position and Orientation
Applied Sciences · 30.09.2023 · 13 (19) · 10901
DOI: 10.3390/app131910901 ↗Kurz gefasst
Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 30.09.2023. Verfasst von Dabao Lao und 3 weiteren Autor:innen. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Scientific and Technological Innovation Foundation of the Shunde Innovation School.
Abstract (Originalsprache)
The positional accuracy and orientation accuracy of industrial robots are crucial technical indicators for determining their applicability in industrial scenarios. However, the majority of current calibration methods for industrial robots only consider positional errors, neglecting the significance of orientation accuracy. This paper presents a more accurate error model and parameter calibration method for industrial robots based on six degrees-of-freedom position and orientation to identify the actual structural parameters. Firstly, based on the modified Denavit–Hartenberg parameters, the transformation errors of the tool coordinate system and measurement coordinate frame were introduced to establish a geometric parameter error model with positional and orientation accuracy as the optimization objectives. Secondly, to address the drawback of falling into local optima when identifying geometric parameters simultaneously, a geometric parameter cross-identification method based on the Levenberg–Marquardt algorithm is proposed. Lastly, the linear relationship between the parameters was analyzed, and a scheme for not calibrating some geometric parameters under specific conditions was given. Simulation results demonstrated that, under the premise of existing transformation errors, the proposed geometric parameter error model can accurately identify the actual structural parameters of industrial robots. After calibration, the positional error at the robot’s flange end decreased from 1.9536 mm to 0.0122 mm, and the orientation error decreased from 1.46 × 10−2 rad to 1.31 × 10−4 rad. Furthermore, compared to identifying the geometric parameters simultaneously, the proposed cross-identification method has a wider convergence range.
Förderung
- Scientific and Technological Innovation Foundation of the Shunde Innovation School
Zitieren
APA
Lao, D., Quan, Y., Wang, F., & Liu, Y. (2023). Error Modeling and Parameter Calibration Method for Industrial Robots Based on 6-DOF Position and Orientation. Applied Sciences, 13(19), 10901. https://doi.org/10.3390/app131910901
Vancouver
Lao D, Quan Y, Wang F, Liu Y. Error Modeling and Parameter Calibration Method for Industrial Robots Based on 6-DOF Position and Orientation. Applied Sciences. 2023;13(19):10901. doi:10.3390/app131910901
BibTeX
@article{Lao2023,
author = {Lao, Dabao and Quan, Yongbin and Wang, Fang and Liu, Yukun},
title = {Error Modeling and Parameter Calibration Method for Industrial Robots Based on 6-DOF Position and Orientation},
journal = {Applied Sciences},
year = {2023},
volume = {13},
number = {19},
pages = {10901},
doi = {10.3390/app131910901}
}
EUVIMED