EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Finite Element Analysis of the Influence of Chamfer Hub Geometry on the Stress Concentrations of Shrink Fits

Eulalia Izard, Roberto García-Martín, Manuel Rodríguez-Martín, Miguel Lorenzo

Applied Sciences · 11.03.2023 · 13 (6) · 3606

DOI: 10.3390/app13063606 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Applied Sciences, online erschienen am 11.03.2023. Verfasst von Eulalia Izard und 3 weiteren Autor:innen. Die Arbeit wurde bisher 11-mal zitiert (Crossref) und nennt 35 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundación Memoria D. Samuel Solorzano Barruso, MCIN/AEI/10.13039/501100011033.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The theoretical expressions commonly used in the design of interference fits do not take into account the huge stress concentrations located at the edges of the hub. This underestimation of the real stress state can induce the incorrect performance of the shaft–hub assembly. Among the different methods to address this problem is the use of chamfer hubs, which are used for reducing such stress concentrations. In this paper, an analysis, performed via finite element method, of the influence of the geometric parameters of a shrink fit with chamfer hubs was carried out with the aim of determining the optimal dimensions for the design of this type of mechanical assembly. To achieve this goal, different chamfer hub geometries were considered: (i) full–chamfer hubs defined by the chamfer angle and (ii) partial–chamfer hubs defined by the chamfer angle and the chamfer height. According to the obtained results, stress concentrations can be reduced by using a full–chamfer hub with chamfer angles within the range 13°–15° depending on the hub thickness. In addition, similar results can be obtained by using partial–chamfer hubs with a chamfer height of half of the hub thickness and chamfer angles within the range 13°–15°. By using these design recommendations, the theoretical equations can be used without underestimating the real stress state.

Förderung

  • Fundación Memoria D. Samuel Solorzano Barruso
  • MCIN/AEI/10.13039/501100011033

Zitieren

APA

Izard, E., García-Martín, R., Rodríguez-Martín, M., & Lorenzo, M. (2023). Finite Element Analysis of the Influence of Chamfer Hub Geometry on the Stress Concentrations of Shrink Fits. Applied Sciences, 13(6), 3606. https://doi.org/10.3390/app13063606

Vancouver

Izard E, García-Martín R, Rodríguez-Martín M, Lorenzo M. Finite Element Analysis of the Influence of Chamfer Hub Geometry on the Stress Concentrations of Shrink Fits. Applied Sciences. 2023;13(6):3606. doi:10.3390/app13063606

BibTeX
@article{Izard2023,
  author = {Izard, Eulalia and García-Martín, Roberto and Rodríguez-Martín, Manuel and Lorenzo, Miguel},
  title = {Finite Element Analysis of the Influence of Chamfer Hub Geometry on the Stress Concentrations of Shrink Fits},
  journal = {Applied Sciences},
  year = {2023},
  volume = {13},
  number = {6},
  pages = {3606},
  doi = {10.3390/app13063606}
}
Kostenlos starten →