Design and Implementation of a Quick-Change End-Effector Control System for Lightweight Robotic Arms in Workpiece Assembly Applications
Actuators · 18.12.2025 · 14 (12) · 619
DOI: 10.3390/act14120619 ↗Kurz gefasst
Fachartikel in der Zeitschrift Actuators, online erschienen am 18.12.2025. Verfasst von Guangxin Luan und 2 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 21 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Science and Technology Department of Shanghai of China, National Natural Science Foundation of China.
Abstract (Originalsprache)
This paper presents a lightweight end-effector quick-change control system for robotic arms, designed for scenarios such as workpiece assembly that require rapid switching between multiple end-effectors. The system utilizes a proprietary quick-change mechanism as its hardware foundation. Its main disk employs a modular and lightweight design compatible with small collaborative robots like the UR3. Motor-driven claws enable automatic tool locking and unlocking. To unify control interfaces for heterogeneous motor-driven tools, this paper proposes a universal peripheral adapter circuit based on the RS485 bus and a tool ID recognition mechanism, establishing a standardized four-wire interface for multi-tool sharing. At the control level, embedded control programs were developed for both the quick-change device and the tool end. An upper-level control platform based on ROS and MoveIt was established to achieve automatic quick-change and task sequence control during typical robotic operations such as “drilling-assembly workpiece.” Statistics from 20 locking time and communication success rate tests, along with 30 complete assembly experiments, demonstrate that the average quick-change locking time is 1.81 s, communication success rate is 100%, and a 93.3% assembly process success rate. These results validate the feasibility and stability of the proposed lightweight robotic arm end-effector quick-change control system in workpiece assembly scenarios, providing an expandable and reproducible quick-change control solution for multi-task operations of lightweight robotic arms.
Förderung
- Science and Technology Department of Shanghai of China
- National Natural Science Foundation of China
Zitieren
APA
Luan, G., Hu, L., & Wang, R. (2025). Design and Implementation of a Quick-Change End-Effector Control System for Lightweight Robotic Arms in Workpiece Assembly Applications. Actuators, 14(12), 619. https://doi.org/10.3390/act14120619
Vancouver
Luan G, Hu L, Wang R. Design and Implementation of a Quick-Change End-Effector Control System for Lightweight Robotic Arms in Workpiece Assembly Applications. Actuators. 2025;14(12):619. doi:10.3390/act14120619
BibTeX
@article{Luan2025,
author = {Luan, Guangxin and Hu, Lingyan and Wang, Raofen},
title = {Design and Implementation of a Quick-Change End-Effector Control System for Lightweight Robotic Arms in Workpiece Assembly Applications},
journal = {Actuators},
year = {2025},
volume = {14},
number = {12},
pages = {619},
doi = {10.3390/act14120619}
}
EUVIMED