Load Sharing On Spur Gear Teeth And Stress Analysis When Contact Ratio Changed
Al-Rafidain Engineering Journal (AREJ) · 01.12.2008 · 16 (5) · 94-101
DOI: 10.33899/1bzj2n58 ↗Kurz gefasst
Fachartikel in der Zeitschrift Al-Rafidain Engineering Journal (AREJ), online erschienen am 01.12.2008. Verfasst von Sabah M.J.ALI und 1 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
The present research work concentrates on the effect of contact ratio change on the stresses generated on meshing gear tooth. Many cases of contact ratio (1.6, 1.7, 1.8, 1.9 & 2.0) had been studied in this research. In each case the value and location of load can be determined on involute of meshing tooth, also the angular position of this tooth for critical loading condition (at the instant when the generated root stresses at the maximum state). (Ansys) programming using F.E.M had been applied for stress analysis on gear model. From this study it is clear that, the highest contact ratio resulted in the lowest generated tooth stresses (i.e. the highest load carrying capacity), this is depending on the value, location and direction of load applied on tooth involute.
Zitieren
APA
M.J.ALI, S., & MOHAMMAD, O. D. (2008). Load Sharing On Spur Gear Teeth And Stress Analysis When Contact Ratio Changed. Al-Rafidain Engineering Journal (AREJ), 16(5), 94-101. https://doi.org/10.33899/1bzj2n58
Vancouver
M.J.ALI S, MOHAMMAD OD. Load Sharing On Spur Gear Teeth And Stress Analysis When Contact Ratio Changed. Al-Rafidain Engineering Journal (AREJ). 2008;16(5):94-101. doi:10.33899/1bzj2n58
BibTeX
@article{MJALI2008,
author = {M.J.ALI, Sabah and MOHAMMAD, Omar D.},
title = {Load Sharing On Spur Gear Teeth And Stress Analysis When Contact Ratio Changed},
journal = {Al-Rafidain Engineering Journal (AREJ)},
year = {2008},
volume = {16},
number = {5},
pages = {94--101},
doi = {10.33899/1bzj2n58}
}
EUVIMED