Flexural and shear performance of concrete beams reinforced with macroscopic carbon nanotubes using finite element modelling
Frontiers in Built Environment · 26.05.2026 · 12
DOI: 10.3389/fbuil.2026.1829487 ↗Kurz gefasst
Fachartikel in der Zeitschrift Frontiers in Built Environment, online erschienen am 26.05.2026. Verfasst von Deborah Wadzani Dauda und 2 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 39 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Carbon nanotubes (CNTs) are one among many materials that are used to reinforce concrete alongside steel bars. They are known for their exceptional mechanical properties which have been found to improve the mechanical performance and crack resistance of cementitious materials Although CNTs are usually incorporated into concrete as nano-fillers, fibres, or powders, this study aimed at using CNTs in a macroscopic form as bars to replace steel bars in reinforcing concrete. Numerical investigation on the flexural and shear performance of concrete beams reinforced with macroscopic CNT bars was carried out using Finite element method (FEM) in ANSYS 17.2. Six simply supported beams each of RCC and macroscopic CNTs comprising Concrete Grades 40, 60, 120, 200, 300, 400 making a total of twelve beams were designed in accordance with ACI 318-19, simulated and analyzed under four-point bending. The results show that the CNT–reinforced beams in comparison to RCC beams had a higher load–carrying capacity which was up to 720 kN in difference and approximately 1.84 times that of RCC beams and this increased with higher concrete grades. From the load–deflection response, CNT–reinforced beams experienced enhanced deformation capacity at most concrete grades, ductility improved as much as 62.7%, while elastic stiffness was consistently higher than RCC beams at all grades, with improvements up to 14.4%. The flexural and shear performances as well outweighed that of RCC beams at most grades with flexural and shear capacities increasing from 496.84kNm to 912.15kNm and from 432.04kN to 793.18 kN respectively representing an improvement of 83.6%. However, when compared to the designed flexure and shear capacities, the CNT–reinforced beams performed better in flexure than shear. Failure in all RCC and macroscopic CNT–reinforced beams was governed by a combined flexure-shear action, but CNT beams had more distributed cracks indicating improved load redistribution before failure.
Zitieren
APA
Dauda, D. W., Chandran, R. B., & Soni, D. K. (2026). Flexural and shear performance of concrete beams reinforced with macroscopic carbon nanotubes using finite element modelling. Frontiers in Built Environment, 12. https://doi.org/10.3389/fbuil.2026.1829487
Vancouver
Dauda DW, Chandran RB, Soni DK. Flexural and shear performance of concrete beams reinforced with macroscopic carbon nanotubes using finite element modelling. Frontiers in Built Environment. 2026;12. doi:10.3389/fbuil.2026.1829487
BibTeX
@article{Dauda2026,
author = {Dauda, Deborah Wadzani and Chandran, Ramesh Babu and Soni, Deepak Kumar},
title = {Flexural and shear performance of concrete beams reinforced with macroscopic carbon nanotubes using finite element modelling},
journal = {Frontiers in Built Environment},
year = {2026},
volume = {12},
doi = {10.3389/fbuil.2026.1829487}
}
EUVIMED