EUVIMEDEUVIMED entdecken
Crossref

Biomimetic grafts from ultrafine fibers for collagenous tissues

Fariza Mukasheva, Ainur Zhanbassynova, Cevat Erisken

Bio-Medical Materials and Engineering · 2024

DOI: 10.3233/bme-230193 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Bio-Medical Materials and Engineering, 2024. Verfasst von Fariza Mukasheva und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical and Materials Engineering, School of Engineering and Digital Sciences, Nazarbayev University, Astana, Kazakhstan. Hauptthemen laut MEDLINE: Tissue Scaffolds, Tissue Engineering, Biomimetic Materials, Collagen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 28 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

BACKGROUND: The ligament is the soft tissue that connects bone to bone and, in case of severe injury or rupture, it cannot heal itself mainly because of its poor vascularity and dynamic nature. Tissue engineering carries the potential to restore the injured tissue functions by utilization of scaffolds mimicking the structure of native ligament. Collagen fibrils in the anterior cruciate ligament (ACL) have a diameter ranging from 20 to 300 nm, which defines the physical and mechanical properties of the tissue. Also, the ACL tissue exhibited a bimodal distribution of collagen fibrils. Currently, the ability to fabricate scaffolds replicating this structure is a significant challenge. OBJECTIVE: This work aims at i) measuring the diameter of collagens of bovine ACL tissue, ii) investigating the fabrication of sub-100 nm fibers, and iii) fabricating aligned scaffolds with bimodal diameter distribution (with two peaks) resembling the healthy ACL structure. It is hypothesized that such scaffolds can be produced by electrospinning polycaprolactone (PCL) solutions. METHODS: To test the hypothesis, various PCL solutions were formulated in acetone and formic acid in combination with pyridine, and electrospun to generate sub-100 nm fibers. Next, this formulation was adjusted to produce nanofibers with a diameter between 100 nm and 200 nm. Finally, these solutions were combined in the co-electrospinning process, i.e., two-spinneret electrospinning, to fabricate biomimetic scaffolds with a bimodal distribution. RESULTS: Electrospinning of 8% and 15% PCL solutions, respectively, resulted in the production of fibers with diameters below and above 100 nm. The combined scaffold exhibited a bimodal distribution of aligned fibers with peaks around 80 and 180 nm, thus mimicking the collagen fibrils of healthy ACL tissue. CONCLUSION: This research is expected to have a society-wide impact because it aims to enhance the health condition and life quality of a wide range of patients.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Tissue ScaffoldsTissue EngineeringBiomimetic MaterialsCollagenPolyestersAnterior Cruciate LigamentAnimalsCattleNanofibersMaterials Testing

Stichwörter der Autor:innen

Ligamentbimodalelectrospinningfiber diameter distributionpolycaprolactone

Substanzen

CollagenPolyesterspolycaprolactone

Autor:innen und Institutionen

  • Department of Chemical and Materials Engineering, School of Engineering and Digital Sciences, Nazarbayev University, Astana, Kazakhstan.

Zitieren

APA

Mukasheva, F., Zhanbassynova, A., & Erisken, C. (2024). Biomimetic grafts from ultrafine fibers for collagenous tissues. Bio-Medical Materials and Engineering. https://doi.org/10.3233/bme-230193

Vancouver

Mukasheva F, Zhanbassynova A, Erisken C. Biomimetic grafts from ultrafine fibers for collagenous tissues. Bio-Medical Materials and Engineering. 2024. doi:10.3233/bme-230193

BibTeX
@article{Mukasheva2024,
  author = {Mukasheva, Fariza and Zhanbassynova, Ainur and Erisken, Cevat},
  title = {Biomimetic grafts from ultrafine fibers for collagenous tissues},
  journal = {Bio-Medical Materials and Engineering},
  year = {2024},
  doi = {10.3233/bme-230193}
}
Kostenlos starten →