Laser Direct Energy Deposition of Stainless Steel 316L:Investigation of Processing Parameters on Porosity andMicrostructural Evolution
Iraqi Journal of Laser · 15.06.2026 · 25 (1) · 33-49
DOI: 10.31900/ijl.v251.563 ↗Kurz gefasst
Fachartikel in der Zeitschrift Iraqi Journal of Laser, online erschienen am 15.06.2026. Verfasst von Samir Noori Ali und 2 weiteren Autor:innen.
Abstract (Originalsprache)
Laser direct energy deposition (LDED) was employed to fabricate low-carbon stainless steel 316L andto evaluate the influence of processing parameters on porosity, relative density, and microhardness. A fiber lasersystem operating at 1070 nm (YLS-3000-CUT, IPG ABB) was used. The spot size was 1.2 mm, the powder feedrate was 9.5 g/min, the layer thickness was 0.2 mm, the carrier gas flow rate was 7.5 L/min, and the shielding gasflow rate was 25 L/min. Laser power (420, 600, and 800 W) and scan speed (20, 25, and 30 mm/s) weresystematically varied, producing nine samples with linear energy densities between 14 and 40 J/mm and volumetricenergy densities from 59 to 167 J/mm³. Microstructural features and pore morphology were examined using opticalmicroscopy and scanning electron microscopy. Porosity and relative density were quantified by full cross-sectionalimage analysis. Microhardness was measured using a Vickers indenter with a 300 g load and 10 s dwell time.Microhardness values ranged from 185.4 to 207.3 HV. Porosity values varied between 0.198% and 0.831%, whilerelative density ranged from 99.169% to 99.802%. Lower volumetric energy densities produced reduced porosityand increased relative density at all scan speeds. The minimum porosity (0.198%) and maximum relative density(99.802%) were obtained at a scan speed of 30 mm/s and a volumetric energy density of 59 J/mm³. The resultsquantify the effect of laser power and scan speed on densification and mechanical response in LDED-processed316L and define a limited processing window for defect minimization.
Zitieren
APA
Ali, S. N., Taha, Z., & Previtali, B. (2026). Laser Direct Energy Deposition of Stainless Steel 316L:Investigation of Processing Parameters on Porosity andMicrostructural Evolution. Iraqi Journal of Laser, 25(1), 33-49. https://doi.org/10.31900/ijl.v251.563
Vancouver
Ali SN, Taha Z, Previtali B. Laser Direct Energy Deposition of Stainless Steel 316L:Investigation of Processing Parameters on Porosity andMicrostructural Evolution. Iraqi Journal of Laser. 2026;25(1):33-49. doi:10.31900/ijl.v251.563
BibTeX
@article{Ali2026,
author = {Ali, Samir Noori and Taha, Ziad and Previtali, Barbara},
title = {Laser Direct Energy Deposition of Stainless Steel 316L:Investigation of Processing Parameters on Porosity andMicrostructural Evolution},
journal = {Iraqi Journal of Laser},
year = {2026},
volume = {25},
number = {1},
pages = {33--49},
doi = {10.31900/ijl.v251.563}
}
EUVIMED