EUVIMEDEUVIMED entdecken
Crossref

Studi Numerik Unjuk Kerja Penggunaan Winglet Pada Heat Exchanger Tipe Compact

Chandra Siregar, Irfansyah Irfansyah

Jurnal Rekayasa Material, Manufaktur dan Energi · 2018

DOI: 10.30596/rmme.v1i1.2432 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jurnal Rekayasa Material, Manufaktur dan Energi, 2018. Verfasst von Chandra Siregar und 1 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The compact heat exchanger is one type of heat exchanger which has an area of heat transfer per unit volume the largest (≥ 400 m2 / m3 for liquids and ≥ 700 m2 / m3 for gases) which is composed of fin and tube. But often found a decrease in heat transfer performance on a heat exchanger. To increase the heat transfer performance, changes are made on the surface of the fin or by adding a vortex generator. In this numerical study vortex generator was added to the winglet delta curve type which aims to determine the flow characteristics and the transfer of heat produced. This numerical study uses solidworks flow simulation software as a numerical simulation tool. Speed variations on the inlet side are 0.5 m / s, 1.15 m / s and 1.8 m / s. Simulation results were obtained by comparing fin using winglet delta curve with those without the winglet delta curve and compared to adding holes on the winglet delta curve. From the simulation results obtained compact heat exchanger which uses the winglet delta curve without and with holes the increase in heat transfer rate ranges from 16.43% - 30.67% compared to a heat exchanger without a winglet delta curve.

Zitieren

APA

Siregar, C., & Irfansyah, I. (2018). Studi Numerik Unjuk Kerja Penggunaan Winglet Pada Heat Exchanger Tipe Compact. Jurnal Rekayasa Material, Manufaktur dan Energi. https://doi.org/10.30596/rmme.v1i1.2432

Vancouver

Siregar C, Irfansyah I. Studi Numerik Unjuk Kerja Penggunaan Winglet Pada Heat Exchanger Tipe Compact. Jurnal Rekayasa Material, Manufaktur dan Energi. 2018. doi:10.30596/rmme.v1i1.2432

BibTeX
@article{Siregar2018,
  author = {Siregar, Chandra and Irfansyah, Irfansyah},
  title = {Studi Numerik Unjuk Kerja Penggunaan Winglet Pada Heat Exchanger Tipe Compact},
  journal = {Jurnal Rekayasa Material, Manufaktur dan Energi},
  year = {2018},
  doi = {10.30596/rmme.v1i1.2432}
}
Kostenlos starten →