EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Hydrolytic Degradation of 3D-Printed Poly (Lactic Acid) Structures

Logan Mulderrig, Franchino Chambers, Taylor A. Isais, Richard Jeske, Yan Li, Justin G. Kennemur, Daniel T. Hallinan

Sustainable Development Research · 2021

DOI: 10.30560/sdr.v3n3p17 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Sustainable Development Research, 2021. Verfasst von Logan Mulderrig und 6 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hydrolytic degradation of commercially available 3D printing filament, i.e. poly (lactic acid) with broad molecular weight distribution was induced by incubating 3D-printed parts in deionized water at 3 temperatures. Small changes in orthogonal dimensions occurred due to relaxation of printing stresses, but no mass or volume loss were detected over the time-frame of the experiments. Molecular weight decreased while polydispersity remained constant. The most sensitive measure of degradation was found to be nondestructive, small-amplitude oscillatory tensile measurements. A rapid decay of tensile storage modulus was found with an exponential decay time constant of about an hour. This work demonstrates that practical monitoring of commercially available PLA degradation can be achieve with linear viscoelastic measurements of modulus.

Zitieren

APA

Mulderrig, L., Chambers, F., Isais, T. A., Jeske, R., Li, Y., Kennemur, J. G., & Hallinan, D. T. (2021). Hydrolytic Degradation of 3D-Printed Poly (Lactic Acid) Structures. Sustainable Development Research. https://doi.org/10.30560/sdr.v3n3p17

Vancouver

Mulderrig L, Chambers F, Isais TA, Jeske R, Li Y, Kennemur JG, et al. Hydrolytic Degradation of 3D-Printed Poly (Lactic Acid) Structures. Sustainable Development Research. 2021. doi:10.30560/sdr.v3n3p17

BibTeX
@article{Mulderrig2021,
  author = {Mulderrig, Logan and Chambers, Franchino and Isais, Taylor A. and Jeske, Richard and Li, Yan and Kennemur, Justin G. and Hallinan, Daniel T.},
  title = {Hydrolytic Degradation of 3D-Printed Poly (Lactic Acid) Structures},
  journal = {Sustainable Development Research},
  year = {2021},
  doi = {10.30560/sdr.v3n3p17}
}
Kostenlos starten →