EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Bolted joint in an experimental and theoretical approaches concerning load type and friction coefficient

Kuba Kryszczyński, Dominik Wilczyński, Krzysztof Wałęsa

Archive of Mechanical Engineering · 16.11.2026 · 1-20

DOI: 10.24425/ame.2026.12677 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Archive of Mechanical Engineering, online erschienen am 16.11.2026. Verfasst von Kuba Kryszczyński und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study examines stress state in bolts during tightening, highlights discrepancy between laboratory tensile-test results and operational conditions. Although torquecontrolled tightening is widely used to generate preload in bolted joints, a substantial part of the applied torque is dissipated by friction rather than transformed into useful axial force. Custom-designed test stand was developed to record axial force and tightening torque simultaneously, in two configurations: standard friction and lowfriction conditions achieved with a thrust rolling bearing. The tests were carried out on M5, M6, and M8 bolts in the strength classes 4.8, 5.8, and 8.8. Additional tensile tests were performed to compare the actual strength in pure tension of the bolts with the reference values of the strength class of the technical standard. The torsional stress in the core was markedly higher under standard-friction conditions and about 60% of torque was lost on under-head friction. Reducing friction under bolt head improved axial force transfer and increased the achieved preload, with lower measured torque. Nevertheless, even in the low-friction setup, the obtained axial force remained below the expected level, in the worst case the measured preload was over 45% belowexpected. The measured data enabled determination of friction coefficients of 𝜇 = 0.205 in the thread and 𝜇 = 0.221 under bolt head in dry steel-steel contact.

Zitieren

APA

Kryszczyński, K., Wilczyński, D., & Wałęsa, K. (2026). Bolted joint in an experimental and theoretical approaches concerning load type and friction coefficient. Archive of Mechanical Engineering, 1-20. https://doi.org/10.24425/ame.2026.12677

Vancouver

Kryszczyński K, Wilczyński D, Wałęsa K. Bolted joint in an experimental and theoretical approaches concerning load type and friction coefficient. Archive of Mechanical Engineering. 2026:1-20. doi:10.24425/ame.2026.12677

BibTeX
@article{Kryszczyski2026,
  author = {Kryszczyński, Kuba and Wilczyński, Dominik and Wałęsa, Krzysztof},
  title = {Bolted joint in an experimental and theoretical approaches concerning load type and friction coefficient},
  journal = {Archive of Mechanical Engineering},
  year = {2026},
  pages = {1--20},
  doi = {10.24425/ame.2026.12677}
}
Kostenlos starten →