An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2
Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering · 2019
DOI: 10.24321/2393.8315.201901 ↗At a glance
Journal article in Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering, 2019. Written by Palwinder Singh.
Abstract (original language)
Electrical Discharge Machining (EDM) is the one of the earliest nontraditional machining processes. Today, many parts used in the aerospace and automotive industries and in the final processes of surgical can be finished by the EDM process. The machining parameters mainly affect the economy of process. This work emphasizes to find the optimization of machining parameters using response surface methodology (RSM)by variation of peak current, pulse time variation so that good Surface Finish (SF) can be achieved with the optimum Material Removal Rate (MRR). It was concluded that with the increasing peak current and pulseon Time (Ton), MRR increases but the surface roughness also starts to increase resulted in poor surface finish whereas with decreasing the pulse off Time (Toff), the surface finish increases but MRR starts to decrease. During the experimentation, Tool Steel-D2 was selected as work specimen with the copper electrode. Surface micrography had been done for the deep analysis to see the effect of machining on the Tool Steel-D2. This study indicates towards the practical feasibility of optimized EDM parameters in multi response conditions. How to cite this article:Singh P, Singh L. An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2. J Adv Res Mfg Mater Sci Met Engr 2019; 6(3&4): 1-7.
Cite
APA
Singh, P. (2019). An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2. Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering. https://doi.org/10.24321/2393.8315.201901
Vancouver
Singh P. An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2. Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering. 2019. doi:10.24321/2393.8315.201901
BibTeX
@article{Singh2019,
author = {Singh, Palwinder},
title = {An Experimental Investigation During Electric Discharge Machining of Tool Steel-D2},
journal = {Journal of Advanced Research in Manufacturing, Material Science & Metallurgical Engineering},
year = {2019},
doi = {10.24321/2393.8315.201901}
}
EUVIMED