EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

On the Dynamics of 3D-printed Gears with Lattice Structure

Mihael Magda, Zoltan-Iosif Korka, Raul-Rusalin Turiac

Studia Universitatis Babeș-Bolyai Engineering · 24.03.2026 · 41-54

DOI: 10.24193/subbeng.2025.4 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Studia Universitatis Babeș-Bolyai Engineering, online erschienen am 24.03.2026. Verfasst von Mihael Magda und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The research investigates the integration of different lattice structures into gear design by applying them to the infill zone, which is located between the hub and rim of the gear. 3D models of the gears with varying lattice structures were created, and these gears were then constrained to a shaft for simulation purposes. Using the SolidWorks simulation module, a study was conducted to determine the interactions of natural frequencies, and the results were investigated. Gear variants V1-4 presented a good balance between mass reduction and higher stiffness, displaying higher natural frequencies overall, where these deformations manifest, in comparison to the original structure V0.

Zitieren

APA

Magda, M., Korka, Z., & Turiac, R. (2026). On the Dynamics of 3D-printed Gears with Lattice Structure. Studia Universitatis Babeș-Bolyai Engineering, 41-54. https://doi.org/10.24193/subbeng.2025.4

Vancouver

Magda M, Korka Z, Turiac R. On the Dynamics of 3D-printed Gears with Lattice Structure. Studia Universitatis Babeș-Bolyai Engineering. 2026:41-54. doi:10.24193/subbeng.2025.4

BibTeX
@article{Magda2026,
  author = {Magda, Mihael and Korka, Zoltan-Iosif and Turiac, Raul-Rusalin},
  title = {On the Dynamics of 3D-printed Gears with Lattice Structure},
  journal = {Studia Universitatis Babeș-Bolyai Engineering},
  year = {2026},
  pages = {41--54},
  doi = {10.24193/subbeng.2025.4}
}
Kostenlos starten →