Design and numerical assessment of an additively manufactured Schwarz diamond triply periodic minimal surface fluid-fluid heat exchanger
Journal of Laser Applications · 01.11.2023 · 35 (4)
DOI: 10.2351/7.0001184 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Laser Applications, online erschienen am 16.11.2023. Verfasst von Tim Röver und 5 weiteren Autor:innen. Die Arbeit wurde bisher 26-mal zitiert (Crossref) und nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
In aerospace, thermal applications demand compact, lightweight, and efficient heat exchangers. Additive manufacturing processes offer the potential to create highly complex structures that are not achievable through traditional manufacturing methods. This work presents the development of an additively manufactured fluid-fluid heat exchanger that shows the potential to enhance the performance, reduce weight, and increase compactness compared to a conventional plate heat exchanger. A numerical model of the conventional plate heat exchanger was created, and fluid dynamics simulations with heat transfer were performed. Validation of the simulations was done by experiments. Then, a novel heat exchanger was designed using a bottom-up approach and investigated at different levels of complexity using computational fluid dynamics. The internal structure of the final heat exchanger consists of a repeating triply periodic Schwarz diamond minimum surface elongated in the direction of flow. The heat exchanger was manufactured with laser powder bed fusion process using AlSi10Mg. It had a 108% higher compactness and 54% lower weight compared to the plate heat exchanger. Numerical analysis yielded the pressure loss in pascal was reduced by 50%–59% while heat transfer in watts was improved by 3%–5%. Future researches should experimentally investigate the thermal and fluid mechanical characteristics of the novel additively manufactured heat exchanger and increase compactness and heat transfer further by analyzing the minimum partition wall thickness and the impact of wall roughness and deposit formation.
Zitieren
APA
Röver, T., Kuehne, M., Bischop, F., Clague, L., Bossen, B., & Emmelmann, C. (2023). Design and numerical assessment of an additively manufactured Schwarz diamond triply periodic minimal surface fluid-fluid heat exchanger. Journal of Laser Applications, 35(4). https://doi.org/10.2351/7.0001184
Vancouver
Röver T, Kuehne M, Bischop F, Clague L, Bossen B, Emmelmann C. Design and numerical assessment of an additively manufactured Schwarz diamond triply periodic minimal surface fluid-fluid heat exchanger. Journal of Laser Applications. 2023;35(4). doi:10.2351/7.0001184
BibTeX
@article{Rver2023,
author = {Röver, Tim and Kuehne, Maxim and Bischop, Floyd and Clague, Leighton and Bossen, Bastian and Emmelmann, Claus},
title = {Design and numerical assessment of an additively manufactured Schwarz diamond triply periodic minimal surface fluid-fluid heat exchanger},
journal = {Journal of Laser Applications},
year = {2023},
volume = {35},
number = {4},
doi = {10.2351/7.0001184}
}
EUVIMED