EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

The impact of delayed placement and resin matrix composition on adhesion between layers of resin composites

Suvi Vallittu, Sufyan Garoushi, Lippo Lassila, Pekka K Vallittu

Biomaterial Investigations in Dentistry · 16.07.2026 · 13 · 593-600

DOI: 10.2340/biid.v13.46529 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Biomaterial Investigations in Dentistry, online erschienen am 16.07.2026. Verfasst von Suvi Vallittu und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department of Biomaterials Science and Turku Clinical Biomaterial Center -TCBC, Institute of Dentistry, University of Turku, Turku, Finland. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

To investigate the effect of delay time in resin composite placement and resin matrix composition on interlayer adhesion between two successive composite layers. Materials and methods: Three experimental resin composites were prepared by mixing 79 wt.% particulate filler with 21 wt.% dimethacrylate-based resin matrices (urethane dimethacrylate/​triethylene glycol dimethacrylate [UDMA/TEGDMA]; ethoxylated bisphenol-A-dimethacrylate/urethane dimethacrylate/​triethylene glycol dimethacrylate [Bis-EMA/UDMA/TEGDMA]; bisphenol A-glycidyl methacrylate/triethylene glycol dimethacrylate [Bis-GMA/TEGDMA]). Fifteen groups of specimens were prepared (n = 6/group), consisting of a cured composite substructure onto which a successive surface layer was applied at different time intervals following light-initiated polymerization (0, 10 minutes, 1, 24, and 72 hours). After 2 days of dry storage at 37°C, interlayer adhesion was evaluated by measuring shear bond strength (SBS) using a universal testing machine. Failure modes were visually assessed. In addition, oxygen inhibition layer (OIL) thickness was measured microscopically, and Vickers hardness and viscosity were determined. Data were analyzed using two-way and one-way analysis of variance followed by Tukey Tukey’s Honestly Significant Difference (HSD) tests (α = 0.05).

Results

SBS values ranged from 10.3 ±2.4 to 24.5 ±3.0 MPa. Both placement delay time and resin matrix composition significantly affected SBS (p < 0.05). SBS decreased significantly when the application of the second successive layer was delayed beyond 1 hour, with the lowest values observed after 72 hours, particularly in Bis-GMA-based composites. The highest SBS was observed in the UDMA/TEGDMA group at 1 hour. Cohesive failure within the substructure was seen in all specimens. The UDMA/TEGDMA group exhibited the lowest OIL thickness (29.35 ± 0.69 µm).

Conclusion

Both incremental application timing and resin matrix composition significantly influenced composite interlayer adhesion. Short delays (10–60 minutes) enhanced interlayer adhesion, whereas prolonged delays (24–72 hours) resulted in a reduction in interlayer adhesion.

Schlagwörter

Stichwörter der Autor:innen

Composite–composite interfacedelayed placementinterlayer adhesionoxygen inhibition layershear bond strength

Autor:innen und Institutionen

  • Department of Biomaterials Science and Turku Clinical Biomaterial Center -TCBC, Institute of Dentistry, University of Turku, Turku, Finland.
  • The Wellbeing Services County of Southwest Finland, Turku, Finland.

Zitieren

APA

Vallittu, S., Garoushi, S., Lassila, L., & Vallittu, P. K. (2026). The impact of delayed placement and resin matrix composition on adhesion between layers of resin composites. Biomaterial Investigations in Dentistry, 13, 593-600. https://doi.org/10.2340/biid.v13.46529

Vancouver

Vallittu S, Garoushi S, Lassila L, Vallittu PK. The impact of delayed placement and resin matrix composition on adhesion between layers of resin composites. Biomaterial Investigations in Dentistry. 2026;13:593-600. doi:10.2340/biid.v13.46529

BibTeX
@article{Vallittu2026,
  author = {Vallittu, Suvi and Garoushi, Sufyan and Lassila, Lippo and Vallittu, Pekka K},
  title = {The impact of delayed placement and resin matrix composition on adhesion between layers of resin composites},
  journal = {Biomaterial Investigations in Dentistry},
  year = {2026},
  volume = {13},
  pages = {593--600},
  doi = {10.2340/biid.v13.46529}
}
Kostenlos starten →