EUVIMEDEUVIMED entdecken
Crossref

Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process

Neslihan ÖZSOY

International Journal of Computational and Experimental Science and Engineering · 30.11.2019 · 5 (3) · 105-111

DOI: 10.22399/ijcesen.590692 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Journal of Computational and Experimental Science and Engineering, online erschienen am 30.11.2019. Verfasst von Neslihan ÖZSOY. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 20 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, optimum machining conditions were determined by investigating the surface roughness of the 7075-T6 aluminum alloy milling, depending on the spindle speed (rpm), feed per tooth (Fz-mm/tooth) and the cooling type parameters. Taguchi experiment design method was used to save time and cost. Experiments were based on the Taguchi L16 orthogonal array and signal/noise (S/N) ratios were used in the evaluation of the test results. Optimum surface roughness values were determined with Taguchi optimization. In addition, variance analysis and regression analysis were performed. Confirmation tests were conducted to verify the work. As a result of the confirmation tests, it was found that the surface roughness optimization in the milling of the 7075-T6 aluminium alloy was successfully applied.

Zitieren

APA

ÖZSOY, N. (2019). Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process. International Journal of Computational and Experimental Science and Engineering, 5(3), 105-111. https://doi.org/10.22399/ijcesen.590692

Vancouver

ÖZSOY N. Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process. International Journal of Computational and Experimental Science and Engineering. 2019;5(3):105-111. doi:10.22399/ijcesen.590692

BibTeX
@article{ZSOY2019,
  author = {ÖZSOY, Neslihan},
  title = {Experimental Investigation of Surface Roughness of Cutting Parameters in T6 Aluminum Alloy Milling Process},
  journal = {International Journal of Computational and Experimental Science and Engineering},
  year = {2019},
  volume = {5},
  number = {3},
  pages = {105--111},
  doi = {10.22399/ijcesen.590692}
}
Kostenlos starten →