A finite element study on the risk of bone loss around posterior short implants in an atrophic mandible
Journal of Prosthodontic Research · 2024 · 69 (1) · 110-119
DOI: 10.2186/jpr.jpr_d_24_00003 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Prosthodontic Research, 2024. Verfasst von Ivan Onone Gialain und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Dentistry, Department of Biomaterials and Oral Biology, University of São Paulo, São Paulo, Brazil. Hauptthemen laut MEDLINE: Finite Element Analysis, Mandible, Alveolar Bone Loss, Dental Implants. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 59 Literaturangaben.
Abstract (Originalsprache)
PURPOSE: This study aimed to evaluate the risk of bone loss around single short molar crown-supporting implants in an atrophic mandible. METHODS: Implants of different lengths (L = 4 or 6 mm) and diameters (Ø = 4.1 or 4.8 mm) were placed in the molar area of an atrophic mandible. Additional control mandible models were simulated for 4.1 mm diameter implants (L = 4, 6, 8, and 10 mm). A vertical masticatory load of 200 N was applied to three or six occlusal contact areas (3ca or 6ca) of the prosthetic crown. The bone strain energy density (SED) of 109.6 µJ/mm3 was assumed to be the pathological threshold for cortical bone. The peri-implant bone resorption risk index (PIBRri) was calculated by dividing the maximum SED of the crestal cortical bone by the SED pathological threshold. RESULTS: Increasing the implant length from 4 to 6 mm, implant diameter from 4.1 to 4.8 mm, and number of contact areas from 3 to 6 reduced the SED and PIBRri values by approximately 20%, 35%, and 40%, respectively, when comparing pairs of models that isolated a specific variable. All models with 6ca had a low bone resorption risk (PIBRri 1.0) resorption risk. CONCLUSIONS: Increasing the diameter or occlusal contact area of a 4 mm short implant in an atrophic mandible resulted in reduced bone resorption risks, similar to or lower than those observed in a regular mandible with standard-length implants.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- School of Dentistry, Department of Biomaterials and Oral Biology, University of São Paulo, São Paulo, Brazil.
- University of Cuiabá, Cuiabá, Brazil.
- Dentistry Division of the Military Hospital of São Paulo Area and School of Dentistry, Department of Stomatology, University of São Paulo, São Paulo, Brazil.
- Minnesota Dental Research Center for Biomaterials and Biomechanics, School of Dentistry, University of Minnesota, Minneapolis, USA.
Zitieren
APA
Gialain, I. O., Gantier-Takano, M. K., Silva, L. F. R. D., Roscoe, M. G., Pinhata-Baptista, O. H., Meira, J. B. C., & Fok, A. S. L. (2024). A finite element study on the risk of bone loss around posterior short implants in an atrophic mandible. Journal of Prosthodontic Research, 69(1), 110-119. https://doi.org/10.2186/jpr.jpr_d_24_00003
Vancouver
Gialain IO, Gantier-Takano MK, Silva LFRD, Roscoe MG, Pinhata-Baptista OH, Meira JBC, et al. A finite element study on the risk of bone loss around posterior short implants in an atrophic mandible. Journal of Prosthodontic Research. 2024;69(1):110-119. doi:10.2186/jpr.jpr_d_24_00003
BibTeX
@article{Gialain2024,
author = {Gialain, Ivan Onone and Gantier-Takano, Marlene Kasumi and Silva, Leonardo Folmer Rodrigues da and Roscoe, Marina Guimarães and Pinhata-Baptista, Otavio Henrique and Meira, Josete Barbosa Cruz and Fok, Alex Siu Lun},
title = {A finite element study on the risk of bone loss around posterior short implants in an atrophic mandible},
journal = {Journal of Prosthodontic Research},
year = {2024},
volume = {69},
number = {1},
pages = {110--119},
doi = {10.2186/jpr.jpr_d_24_00003}
}
EUVIMED