EUVIMEDEUVIMED entdecken
Crossref

TEMPERATURE AND GEOMETRY ANALYSIS IN N-LAYER WIRE ARC ADDITIVE MANUFACTURING USING GMAW AND ER70S-6 FILLER

Mohammad Azwar Amat, Agus Sifa, Muhammad Luthfi, Arif Novianto, Daniel Leonardo Panjaitan

Jurnal Rekayasa Mesin · 15.12.2025 · 16 (3) · 1055-1067

DOI: 10.21776/jrm.v16i3.1941 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Jurnal Rekayasa Mesin, online erschienen am 15.12.2025. Verfasst von Mohammad Azwar Amat und 4 weiteren Autor:innen.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

WAAM products produce a relatively rough and less precise final surface. Therefore, this study investigated and analyzed the geometric dimensions of the product at each layer and cycle time to achieve N-layers with the aim of obtaining a baseline operational time and achieving WAAM dimensional accuracy of less than ±1 mm deviation. The dimensional measurement method was carried out using a Dinolite photograph, 3-D scanning, and vernier caliper. The cycle time or downtime during the WAAM process was 130 minutes for TS 200 mm/min. TS 200 produced the most consistent thickness with the lowest thickness standard deviation of ±0.49 mm, the highest material efficiency with 45.7% of the material becoming product, and 54.3% of the material being wasted. The product produced by TS 200 mm/min has dimensions of 85 × 4 × 20 mm³.

Zitieren

APA

Amat, M. A., Sifa, A., Luthfi, M., Novianto, A., & Panjaitan, D. L. (2025). TEMPERATURE AND GEOMETRY ANALYSIS IN N-LAYER WIRE ARC ADDITIVE MANUFACTURING USING GMAW AND ER70S-6 FILLER. Jurnal Rekayasa Mesin, 16(3), 1055-1067. https://doi.org/10.21776/jrm.v16i3.1941

Vancouver

Amat MA, Sifa A, Luthfi M, Novianto A, Panjaitan DL. TEMPERATURE AND GEOMETRY ANALYSIS IN N-LAYER WIRE ARC ADDITIVE MANUFACTURING USING GMAW AND ER70S-6 FILLER. Jurnal Rekayasa Mesin. 2025;16(3):1055-1067. doi:10.21776/jrm.v16i3.1941

BibTeX
@article{Amat2025,
  author = {Amat, Mohammad Azwar and Sifa, Agus and Luthfi, Muhammad and Novianto, Arif and Panjaitan, Daniel Leonardo},
  title = {TEMPERATURE AND GEOMETRY ANALYSIS IN N-LAYER WIRE ARC ADDITIVE MANUFACTURING USING GMAW AND ER70S-6 FILLER},
  journal = {Jurnal Rekayasa Mesin},
  year = {2025},
  volume = {16},
  number = {3},
  pages = {1055--1067},
  doi = {10.21776/jrm.v16i3.1941}
}
Kostenlos starten →