Design of a dual-finger 3D-printed gripper with a low-cost ToF-based force sensor
Academia Engineering · 2024
DOI: 10.20935/acadeng7356 ↗Kurz gefasst
Fachartikel in der Zeitschrift Academia Engineering, 2024. Verfasst von Bryan Kisaingu Mutinda und 2 weiteren Autor:innen. Die Arbeit nennt 22 Literaturangaben.
Abstract (Originalsprache)
This study examined the use of a low-cost time-of-flight (ToF) sensor to measure forces on a robotic gripper. A novel, dual-finger, low-cost gripper with changeable fingers was designed and 3D printed. The gripper design was combined with a set of low-cost springs and the ToF sensor. Following a calibration procedure of the elastic, the gripper leverages on the linear elasticity of the springs to convert the ToF-estimated displacement into a force measurement. Calibration was performed with a six Degrees of Freedom (DoF) IIT FT17S/T miniature force sensor. An Arduino Uno embedded controller was used to design an end-user interface between the robotic gripper and the operator: a keypad allowed for setting specific gripping forces and reading the fingers’ displacement on the Arduino serial monitor. An Organic Liquid Crystal Display (OLCD) external display was also implemented to improve the end-user experience. This study showed that low-cost systems can be used to design, manufacture, and integrate robotic devices: the precision and accuracy of such a solution have been discussed, with consideration on how to improve the design through the integration of an Organic Light-Emitting Diode (OLED) 128x64 Pixel SSD1306.
Zitieren
APA
Mutinda, B. K., Manolescu, D., & Secco, E. L. (2024). Design of a dual-finger 3D-printed gripper with a low-cost ToF-based force sensor. Academia Engineering. https://doi.org/10.20935/acadeng7356
Vancouver
Mutinda BK, Manolescu D, Secco EL. Design of a dual-finger 3D-printed gripper with a low-cost ToF-based force sensor. Academia Engineering. 2024. doi:10.20935/acadeng7356
BibTeX
@article{Mutinda2024,
author = {Mutinda, Bryan Kisaingu and Manolescu, Denis and Secco, Emanuele Lindo},
title = {Design of a dual-finger 3D-printed gripper with a low-cost ToF-based force sensor},
journal = {Academia Engineering},
year = {2024},
doi = {10.20935/acadeng7356}
}
EUVIMED