Effect of low-energy laser peening on properties of NiCrBSi-WC/Co coating
Green Manufacturing Open · 2024
DOI: 10.20517/gmo.2024.032701 ↗Kurz gefasst
Fachartikel in der Zeitschrift Green Manufacturing Open, 2024. Verfasst von Longlong Zhou und 6 weiteren Autor:innen. Die Arbeit nennt 44 Literaturangaben.
Abstract (Originalsprache)
Low-energy laser peening (LE-LP) is a green and pollution-free surface deformation strengthening technology. In this work, LE-LP was used to improve the properties of NiCrBSi-WC/Co (Ni-WC) coating. The investigation focused on the impact of LE-LP on the coating microstructure, microhardness, residual stress, and tribological properties. The results showed that although laser hot melting damaged the coating surface, the phase structure of the coatings did not change significantly. The coating’s hardness increased yet its surface roughness decreased as a result of the laser peening. Concurrently, after the LE-LP treatment, a residual compressive stress with an average value of -236 MPa was tested on the surface of the coatings. The average wear volume of the coating was reduced from 11.64 × 10-2 to 6.9 × 10-2 mm3, and the average wear rate was reduced from 4.31 × 10-5 to 2.55 × 10-5/N·mm3.
Zitieren
APA
Zhou, L., Guo, W., Zhu, H., Liu, X., Zhou, X., Cai, Z., & Xing, Z. (2024). Effect of low-energy laser peening on properties of NiCrBSi-WC/Co coating. Green Manufacturing Open. https://doi.org/10.20517/gmo.2024.032701
Vancouver
Zhou L, Guo W, Zhu H, Liu X, Zhou X, Cai Z, et al. Effect of low-energy laser peening on properties of NiCrBSi-WC/Co coating. Green Manufacturing Open. 2024. doi:10.20517/gmo.2024.032701
BibTeX
@article{Zhou2024,
author = {Zhou, Longlong and Guo, Weiling and Zhu, Hefa and Liu, Xiaohong and Zhou, Xinyuan and Cai, Zhenbing and Xing, Zhiguo},
title = {Effect of low-energy laser peening on properties of NiCrBSi-WC/Co coating},
journal = {Green Manufacturing Open},
year = {2024},
doi = {10.20517/gmo.2024.032701}
}
EUVIMED