Development and CFD study of vortex burner device for oxy-fuel combustion chamber
Clean Energy Science and Technology · 20.04.2026
DOI: 10.18686/cest794 ↗Kurz gefasst
Fachartikel in der Zeitschrift Clean Energy Science and Technology, online erschienen am 20.04.2026. Verfasst von Sergey Osipov und 4 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
This article presents a comprehensive research and development effort focused on the design of a vortex burner device intended to enable stable oxy fuel combustion of natural gas in a supercritical carbon dioxide (sCO2) environment, as used in the Allam cycle for zero emission power generation. The prototype burner, featuring a conical bluff body, was systematically analyzed using advanced numerical simulations incorporating detailed chemical kinetics. Optimization studies identified the most suitable combustion parameters, namely an oxidizer excess coefficient α = 1.05. This parameter choice is justified by the fact that it yields acceptable emissions of carbon monoxide (CO) and unburned hydrocarbons (UHC) while maintaining a reasonable level of auxiliary power consumption by the air separation unit (ASU). In the numerical investigation employing the prototype configuration, the maximum stable mass fraction of CO2 in the oxidizer diluent mixture (γ) was found to be 0.82, beyond which flame detachment occurred. Through iterative design enhancements—specifically, replacing the conical bluff body with a hemispherical perforated bluff body and incorporating a diffuser-shaped outlet section—the burner configuration was substantially improved. These modifications enhanced flame stability and enabled a significant increase in γ to 0.867. As a result, the peak process temperature was reduced by more than 400 K, while CO emissions decreased by over a factor of 17 compared to the prototype, with unburned hydrocarbon levels remaining low.
Zitieren
APA
Osipov, S., Vegera, A., Golosova, P., Zlyvko, O., & Malenkov, A. (2026). Development and CFD study of vortex burner device for oxy-fuel combustion chamber. Clean Energy Science and Technology. https://doi.org/10.18686/cest794
Vancouver
Osipov S, Vegera A, Golosova P, Zlyvko O, Malenkov A. Development and CFD study of vortex burner device for oxy-fuel combustion chamber. Clean Energy Science and Technology. 2026. doi:10.18686/cest794
BibTeX
@article{Osipov2026,
author = {Osipov, Sergey and Vegera, Andrey and Golosova, Polina and Zlyvko, Olga and Malenkov, Aleksey},
title = {Development and CFD study of vortex burner device for oxy-fuel combustion chamber},
journal = {Clean Energy Science and Technology},
year = {2026},
doi = {10.18686/cest794}
}
EUVIMED