EUVIMEDSkopri EUVIMED
Open access · CC BY 4.0

Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants

Andrey Rogalev, Daniil Patorkin, Viacheslav Murashov, Vladimir Korolev, Alexey Malenkov

Clean Energy Science and Technology · 2026-11-20

DOI: 10.18686/cest1073 ↗

At a glance

Journal article in Clean Energy Science and Technology, published online on 2026-11-20. Written by Andrey Rogalev and 4 co-authors. 28 references. The full text is freely available (open access, CC BY 4.0).

AstrattDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Widespread commercial deployment of innovative nuclear power plant designs is frequently constrained by the high specific capital cost of installed capacity. A promising solution involves transitioning from traditional steam-water loops to supercritical carbon dioxide (s-CO2) Brayton cycles. According to the literature, this approach enables a substantial reduction in the size and mass of turbomachinery and heat exchangers, thereby reducing overall capital expenditures. This study aims to select and thermodynamically optimize an s-CO2 cycle configuration to ensure maximum energy efficiency when integrated with the 10 MW High Temperature Gas-cooled Reactor (HTR-10) high-temperature gas-cooled reactor. Thermodynamic modeling was performed in Python using the CoolProp library. The Nelder-Mead simplex method was applied to determine optimal operating parameters—low pressure and recompression fraction—across turbine inlet pressures ranging from 12 to 35 MPa. Three CO2 cycle schemes were evaluated: simple, recuperative, and recompression. Results showed the simple Brayton cycle yields the lowest thermal efficiency (23.6%). Adding recuperation increases efficiency to 42.9%. The recompression scheme achieves the highest energy efficiency, reaching a maximum thermal efficiency of 50.6% at an initial pressure of 30 MPa, a cooler pressure of 7.8 MPa, and a recompression fraction of 0.67. A parametric zone of maximum efficiency was identified between 28 and 31 MPa. Ultimately, subject to the adopted assumptions, transitioning to a recompression s-CO2 cycle allows the thermal efficiency to be nearly doubled compared to the baseline HTR-10 plant design. Optimizing parameters near the critical CO2 region minimizes compression costs and enhances recuperation.

Cite

APA

Rogalev, A., Patorkin, D., Murashov, V., Korolev, V., & Malenkov, A. (2026). Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants. Clean Energy Science and Technology. https://doi.org/10.18686/cest1073

Vancouver

Rogalev A, Patorkin D, Murashov V, Korolev V, Malenkov A. Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants. Clean Energy Science and Technology. 2026. doi:10.18686/cest1073

BibTeX
@article{Rogalev2026,
  author = {Rogalev, Andrey and Patorkin, Daniil and Murashov, Viacheslav and Korolev, Vladimir and Malenkov, Alexey},
  title = {Thermodynamic analysis of recompression Brayton power cycle for nuclear power plants},
  journal = {Clean Energy Science and Technology},
  year = {2026},
  doi = {10.18686/cest1073}
}
Start for free →