EUVIMEDOpdag EUVIMED
Crossref

Alternating Current Etching Method for Fabrication of High-performance Aluminum Electrolytic Capacitors

Yu-Chi Lin, Teen-Hang Meen, Tung-Lung Wu, Min-Lang Yang, Kao-Wei Min

Sensors and Materials · 2026-07-27 · 38 (7) · 3979

DOI: 10.18494/sam5903 ↗

At a glance

Journal article in Sensors and Materials, published on 2026-07-27. Written by Yu-Chi Lin and 4 co-authors.

AbstractBibliografiske oplysningerCiteRelated studies

Abstract (original language)

We optimized a multistage electrochemical etching method for fabricating high-performance aluminum electrolytic capacitors using alternating current (AC) to maximize electrostatic capacitance while preserving the mechanical properties of high-purity aluminum foil. The etching process was systematically investigated under various AC frequencies, current densities, durations, solution compositions, and aluminum ion concentrations. Pretreatment and chemical modification with phosphoric acid (H 3 PO 4 ) provided a highly uniform corrosion pit distribution, preventing localized over-dissolution. The optimal etching conditions were identified as a solution containing 350 mL/L HCl, 15 mL/L HNO 3 , 15 mL/L H 3 PO 4 , and 5 g/L Al 3+ , a temperature of 35 °C, a current density of 0.6 A/cm 2 , and a four-stage frequency-stepping profile of 30–30–25–20 Hz for a total etching time of 120 s. Under these conditions, the 50-μm-thick aluminum foil (99.99% purity) achieved a peak specific capacitance of 510.2 μF/cm 2 , indicating a >20% improvement over conventional single-stage methods. Microstructural analysis revealed a highly dense pit network with an average pit diameter of 180–240 nm, a nucleation density of 4.2 × 10 9 pits/cm 2 , an average surface roughness of 1.68 μm, and an exceptional surface enlargement factor of approximately 96.5. Lattice orientations of [220], [311], [200], and [422] in this order contributed to this surface expansion. Process reliability was confirmed by a low capacitance coefficient of variation (

Cite

APA

Lin, Y., Meen, T., Wu, T., Yang, M., & Min, K. (2026). Alternating Current Etching Method for Fabrication of High-performance Aluminum Electrolytic Capacitors. Sensors and Materials, 38(7), 3979. https://doi.org/10.18494/sam5903

Vancouver

Lin Y, Meen T, Wu T, Yang M, Min K. Alternating Current Etching Method for Fabrication of High-performance Aluminum Electrolytic Capacitors. Sensors and Materials. 2026;38(7):3979. doi:10.18494/sam5903

BibTeX
@article{Lin2026,
  author = {Lin, Yu-Chi and Meen, Teen-Hang and Wu, Tung-Lung and Yang, Min-Lang and Min, Kao-Wei},
  title = {Alternating Current Etching Method for Fabrication of High-performance Aluminum Electrolytic Capacitors},
  journal = {Sensors and Materials},
  year = {2026},
  volume = {38},
  number = {7},
  pages = {3979},
  doi = {10.18494/sam5903}
}
Start for free →