EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

VACUUM COMPONENTS OBTAINED BY SLA 3D PRINTING FOR HIGH-VACUUM APPLICATIONS

Henrique Chaves Gulino, Ricardo Cardoso Rangel, Francisco Tadeu Degasperi

Revista Brasileira de Aplicações de Vácuo · 08.05.2026 · 45 (1)

DOI: 10.17563/rbav.v45i1.1258 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Revista Brasileira de Aplicações de Vácuo, online erschienen am 08.05.2026. Verfasst von Henrique Chaves Gulino und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work presents the development and evaluation of KF-25 standard flanges fabricated by 3D printing using stereolithography (SLA) for application in high vacuum systems. The aim is to provide a low-cost, fast, and geometrically flexible alternative to conventional metallic components for laboratory applications. The parts were modeled using Autodesk Inventor and printed with a photopolymer resin on an Anycubic Photon Mono 4K printer. One sample was coated with a 1 μm aluminum layer via thermal evaporation (PVD). Optical microscopy revealed continuous surfaces with no visible pores or air pockets, even at the micrometer scale. Pump-down tests were performed using the Edwards Auto 306 vacuum system, where the original aluminum flange was replaced with the printed samples. Both the untreated and the coated flanges reached final pressures on the order of 10-5 mbar. The aluminum-coated sample exhibited improved pressure stability over time, indicating reduced outgassing. The results demonstrate that SLA-printed flanges can be effectively used in real high vacuum conditions, offering significant advantages in terms of fabrication time, cost, and design flexibility. A discussion of the vacuum system and an estimated calculation of its degassing rate are performed. This study provides a promising pathway for future applications in more complex geometries and customized vacuum setups.

Zitieren

APA

Gulino, H. C., Rangel, R. C., & Degasperi, F. T. (2026). VACUUM COMPONENTS OBTAINED BY SLA 3D PRINTING FOR HIGH-VACUUM APPLICATIONS. Revista Brasileira de Aplicações de Vácuo, 45(1). https://doi.org/10.17563/rbav.v45i1.1258

Vancouver

Gulino HC, Rangel RC, Degasperi FT. VACUUM COMPONENTS OBTAINED BY SLA 3D PRINTING FOR HIGH-VACUUM APPLICATIONS. Revista Brasileira de Aplicações de Vácuo. 2026;45(1). doi:10.17563/rbav.v45i1.1258

BibTeX
@article{Gulino2026,
  author = {Gulino, Henrique Chaves and Rangel, Ricardo Cardoso and Degasperi, Francisco Tadeu},
  title = {VACUUM COMPONENTS OBTAINED BY SLA 3D PRINTING FOR HIGH-VACUUM APPLICATIONS},
  journal = {Revista Brasileira de Aplicações de Vácuo},
  year = {2026},
  volume = {45},
  number = {1},
  doi = {10.17563/rbav.v45i1.1258}
}
Kostenlos starten →