EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Intelligent Control Method for Continuous Miner Cutting Parameters Based on Strength Constraints

Xunan Liu, Yongqiang Dong, Jianzhuo Zhang, Yadong Wang, Lijuan Zhao

Eksploatacja i Niezawodność – Maintenance and Reliability · 15.07.2026

DOI: 10.17531/ein/223922 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Eksploatacja i Niezawodność – Maintenance and Reliability, online erschienen am 15.07.2026. Verfasst von Xunan Liu und 4 weiteren Autor:innen. Die Arbeit nennt 30 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This study addresses the insufficient dynamic strength and low energy efficiency of continuous miners in complex coal seams. A rigid-flexible coupled virtual prototype of the EML340 miner revealed that stress at the cutting arm's hydraulic cylinder connection exceeds the allowable limit (125 MPa). Based on single-factor analysis of cutting parameters and coal-rock hardness, an intelligent Fuzzy Neural Network (FNN) controller was designed to optimize performance under stress constraints. Co-simulation using ADAMS and MATLAB/Simulink demonstrates that the system adaptively adjusts rotational and swing speeds in response to hardness variations. Compared with PID control, the FNN strategy reduces settling time by 87.5%, stress overshoot by 28.6%, and specific cutting energy by 9.3%, ensuring safety while enhancing efficiency. Simulation accuracy was validated via a physical cutting test bench, with a maximum relative error of 4.92% in vibration characteristics. This research provides a technical solution for achieving intelligent, efficient, and safe cutting in continuous miners.

Zitieren

APA

Liu, X., Dong, Y., Zhang, J., Wang, Y., & Zhao, L. (2026). Intelligent Control Method for Continuous Miner Cutting Parameters Based on Strength Constraints. Eksploatacja i Niezawodność – Maintenance and Reliability. https://doi.org/10.17531/ein/223922

Vancouver

Liu X, Dong Y, Zhang J, Wang Y, Zhao L. Intelligent Control Method for Continuous Miner Cutting Parameters Based on Strength Constraints. Eksploatacja i Niezawodność – Maintenance and Reliability. 2026. doi:10.17531/ein/223922

BibTeX
@article{Liu2026,
  author = {Liu, Xunan and Dong, Yongqiang and Zhang, Jianzhuo and Wang, Yadong and Zhao, Lijuan},
  title = {Intelligent Control Method for Continuous Miner Cutting Parameters Based on Strength Constraints},
  journal = {Eksploatacja i Niezawodność – Maintenance and Reliability},
  year = {2026},
  doi = {10.17531/ein/223922}
}
Kostenlos starten →