A fast and simple bonding method for low cost microfluidic chip fabrication
Journal of Electrical Engineering · 01.01.2018 · 69 (1) · 72-78
DOI: 10.1515/jee-2018-0010 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Electrical Engineering, online erschienen am 07.03.2018. Verfasst von Zhifu Yin und 1 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).
Abstract (Originalsprache)
With the development of the microstructure fabrication technique, microfluidic chips are widely used in biological and medical researchers. Future advances in their commercial applications depend on the mass bonding of microfluidic chip. In this study we are presenting a simple, low cost and fast way of bonding microfluidic chips at room temperature. The influence of the bonding pressure on the deformation of the microchannel and adhesive tape was analyzed by numerical simulation. By this method, the microfluidic chip can be fully sealed at low temperature and pressure without using any equipment. The dye water and gas leakage test indicated that the microfluidic chip can be bonded without leakage or block and its bonding strength can up to 0.84 MPa.
Zitieren
APA
Yin, Z., & Zou, H. (2018). A fast and simple bonding method for low cost microfluidic chip fabrication. Journal of Electrical Engineering, 69(1), 72-78. https://doi.org/10.1515/jee-2018-0010
Vancouver
Yin Z, Zou H. A fast and simple bonding method for low cost microfluidic chip fabrication. Journal of Electrical Engineering. 2018;69(1):72-78. doi:10.1515/jee-2018-0010
BibTeX
@article{Yin2018,
author = {Yin, Zhifu and Zou, Helin},
title = {A fast and simple bonding method for low cost microfluidic chip fabrication},
journal = {Journal of Electrical Engineering},
year = {2018},
volume = {69},
number = {1},
pages = {72--78},
doi = {10.1515/jee-2018-0010}
}
EUVIMED