EUVIMEDEUVIMED entdecken
Crossref

Influence of the process parameters on the mechanical strength of direct screw fastened SMC/BMC components

Elmar Moritzer, Christian Held

International Polymer Processing · 26.05.2026 · 41 (2) · 234-243

DOI: 10.1515/ipp-2025-0073 ↗

Kurz gefasst

Fachartikel in der Zeitschrift International Polymer Processing, online erschienen am 20.03.2026. Verfasst von Elmar Moritzer und 1 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 19 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Thermosetting molding compounds such as sheet molding compound (SMC) and bulk molding compound (BMC) are attractive alternatives to high-temperature thermoplastics and light metals for lightweight parts, but detachable joints require suitable joining methods. This work evaluates the feasibility of direct screw fastening in SMC/BMC and quantifies how boss geometry and processing parameters affect pull-out strength. Two SMC grades (electrical and car-body) were compression molded and one BMC grade was injection molded; screw bosses with systematically varied outer and core-hole diameters were produced and assembled with thread-forming/cutting screws. Quasi-static pull-out tests ( n = 5) were complemented by Rubber Process Analyzer (RPA) viscosity measurements and X-ray computed tomography (CT) to relate mechanical performance to process-induced defects. Direct screwing proved feasible, reaching pull-out forces up to 2.5 kN for the electrical SMC with a 5 mm screw. The car-body SMC showed markedly lower strengths due to porous/missing material in the core-hole region, consistent with its substantially lower viscosity (RPA). For BMC, weld lines and internal cavities triggered radial cracking or boss bursting during screw insertion; increasing holding pressure and reducing volume flow mitigated defects but only modestly improved strength. Overall, load capacity is governed mainly by material-dependent viscosity effects during cavity filling rather than by mold temperature or pressure within the investigated window, highlighting the need for geometry-specific process control and application-oriented material selection for robust direct screw joints in thermosets.

Zitieren

APA

Moritzer, E., & Held, C. (2026). Influence of the process parameters on the mechanical strength of direct screw fastened SMC/BMC components. International Polymer Processing, 41(2), 234-243. https://doi.org/10.1515/ipp-2025-0073

Vancouver

Moritzer E, Held C. Influence of the process parameters on the mechanical strength of direct screw fastened SMC/BMC components. International Polymer Processing. 2026;41(2):234-243. doi:10.1515/ipp-2025-0073

BibTeX
@article{Moritzer2026,
  author = {Moritzer, Elmar and Held, Christian},
  title = {Influence of the process parameters on the mechanical strength of direct screw fastened SMC/BMC components},
  journal = {International Polymer Processing},
  year = {2026},
  volume = {41},
  number = {2},
  pages = {234--243},
  doi = {10.1515/ipp-2025-0073}
}
Kostenlos starten →