Study on mechanical properties and damage mechanism of 3D printed carbon fiber reinforced composite laminates
High Temperature Materials and Processes · 23.01.2026 · 45 (1)
DOI: 10.1515/htmp-2025-0127 ↗Kurz gefasst
Fachartikel in der Zeitschrift High Temperature Materials and Processes, online erschienen am 15.07.2026. Verfasst von Meiqing Wan und 7 weiteren Autor:innen. Die Arbeit nennt 27 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
The mechanical properties and damage mechanism of 3D printed carbon fiber reinforced composite laminates were studied. Through the combination of experiment, theoretical analysis and numerical simulation, the mechanical response and failure mode under tensile and three-point bending loads were systematically discussed. The experimental results show that the tensile failure modes of 3D printed carbon fiber reinforced composite laminates are fiber fracture, resin matrix section fracture and fiber pull-out when subjected to tensile load. Under the three-point bending load, the damage gradually expands from the bottom fiber layer to the neutral layer, and the failure modes are matrix crack, interlayer separation and fiber fracture. The tensile strength of the material can reach 46.29 MPa, and the bending strength is 70.13 MPa, the prediction accuracies of maximum tensile load, bending strength and bending modulus are 94 %, 97 % and 97 %. Based on the Hashin failure criterion, a damage model was established to accurately predict the mechanical response and damage mechanism under tension and three-point bending. The results of this study can provide experimental and numerical basis for the design of high-strength lightweight structures, and provide reference for the application of additive manufacturing composites in aerospace, automotive and high-performance engineering structures.
Zitieren
APA
Wan, M., Zhou, X., Sun, Z., Chen, X., Yang, C., Xie, J., Chen, C., & Wang, Z. (2026). Study on mechanical properties and damage mechanism of 3D printed carbon fiber reinforced composite laminates. High Temperature Materials and Processes, 45(1). https://doi.org/10.1515/htmp-2025-0127
Vancouver
Wan M, Zhou X, Sun Z, Chen X, Yang C, Xie J, et al. Study on mechanical properties and damage mechanism of 3D printed carbon fiber reinforced composite laminates. High Temperature Materials and Processes. 2026;45(1). doi:10.1515/htmp-2025-0127
BibTeX
@article{Wan2026,
author = {Wan, Meiqing and Zhou, Xuejun and Sun, Zengxi and Chen, Xin and Yang, Chunlin and Xie, Jiuming and Chen, Chaoyun and Wang, Ziqiu},
title = {Study on mechanical properties and damage mechanism of 3D printed carbon fiber reinforced composite laminates},
journal = {High Temperature Materials and Processes},
year = {2026},
volume = {45},
number = {1},
doi = {10.1515/htmp-2025-0127}
}
EUVIMED