Microstructure and Mechanical Properties of Low-Carbon Steels Quenched and Tempered after Gas Carburizing, Carbonitriding, and Nitriding
HTM Journal of Heat Treatment and Materials · 20.06.2026 · 81 (3) · 102-114
DOI: 10.1515/htm-2026-0008 ↗Kurz gefasst
Fachartikel in der Zeitschrift HTM Journal of Heat Treatment and Materials, online erschienen am 22.06.2026. Verfasst von K. Kawata und 1 weiteren Autor:innen. Die Arbeit nennt 11 Literaturangaben.
Abstract (Originalsprache)
In this study, low-carbon steel specimens were subjected to gas carburizing, carbonitriding, or nitriding at 800 °C, followed by oil quenching and tempering at 300 °C. The investigation focused on the effects of carbon and nitrogen on the resulting microstructure and mechanical properties. The carburized specimens consisted of martensite, fine pearlite, and a small amount of retained austenite. In contrast, the carbonitrided specimens were composed of martensite and retained austenite, while the nitrided specimens exhibited a microstructure of martensite, retained austenite, and pores. The amount of retained austenite in the specimens after quenching was observed to be higher in specimens with a larger amount of nitrogen. X-ray diffraction (XRD) analysis revealed that the carbonitrided and nitrided specimens after tempering had higher amounts of γ’-Fe 4 N phase as the nitrogen content increased. Furthermore, transmission electron microscopy (TEM) and selected area electron diffraction (SAED) analysis confirmed the precipitation of fine γ’-Fe 4 N and ε-Fe 3 (N, C) phases in the subsurface region of the tempered carbonitrided samples with a high nitrogen-to-carbon ratio. Except for the nitrided specimens where pore formation occurred, surface hardness after tempering increased in correlation with nitrogen content. Carbonitriding with a higher nitrogen-to-carbon ratio markedly improved the wear resistance of low-carbon steel.
Zitieren
APA
Kawata, K., & Kidachi, T. (2026). Microstructure and Mechanical Properties of Low-Carbon Steels Quenched and Tempered after Gas Carburizing, Carbonitriding, and Nitriding. HTM Journal of Heat Treatment and Materials, 81(3), 102-114. https://doi.org/10.1515/htm-2026-0008
Vancouver
Kawata K, Kidachi T. Microstructure and Mechanical Properties of Low-Carbon Steels Quenched and Tempered after Gas Carburizing, Carbonitriding, and Nitriding. HTM Journal of Heat Treatment and Materials. 2026;81(3):102-114. doi:10.1515/htm-2026-0008
BibTeX
@article{Kawata2026,
author = {Kawata, K. and Kidachi, T.},
title = {Microstructure and Mechanical Properties of Low-Carbon Steels Quenched and Tempered after Gas Carburizing, Carbonitriding, and Nitriding},
journal = {HTM Journal of Heat Treatment and Materials},
year = {2026},
volume = {81},
number = {3},
pages = {102--114},
doi = {10.1515/htm-2026-0008}
}
EUVIMED