EUVIMEDEUVIMED entdecken
Crossref

Numerical investigation of the effects of dry gas model and wet steam model in solar-driven refrigeration ejector system

Honglun Cong, Jiao Zhang

Chemical Product and Process Modeling · 22.02.2024 · 19 (1) · 69-80

DOI: 10.1515/cppm-2023-0042 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Chemical Product and Process Modeling, online erschienen am 16.10.2023. Verfasst von Honglun Cong und 1 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 47 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Nowadays, the use of equipment with little pollution is essential due to the increase in the planet’s temperature. Ejectors are considered one of the equipment with no pollution, and their failure rate is low due to the lack of moving parts. Also, scholars have recently focused on improving the efficiency of industrial equipment. The use of accurate modeling is required to improve steam ejector performance. In a steam ejector, non-equilibrium condensation creates a two-phase flow situation. The wet steam model, used in this study, characterizes this two-phase flow. The study’s objective was to compare this wet steam model with the dry gas model. In the wet steam model, the liquid mass fraction is 0.25, and its calculated entrainment ratio is lower than the dry gas model, closely matching experimental observations. The dry gas model reaches a maximum Mach number of about 5, while the wet steam model approximates 4. A significant temperature difference exists between the two models, with the dry gas model indicating lower temperatures compared to the wet steam model. Diagonal shocks and expansion waves are evident in the mixing chamber, fixed cross-section, and diffuser. These phenomena occur with greater intensity and a slight delay in the wet steam model compared to the dry gas model.

Zitieren

APA

Cong, H., & Zhang, J. (2024). Numerical investigation of the effects of dry gas model and wet steam model in solar-driven refrigeration ejector system. Chemical Product and Process Modeling, 19(1), 69-80. https://doi.org/10.1515/cppm-2023-0042

Vancouver

Cong H, Zhang J. Numerical investigation of the effects of dry gas model and wet steam model in solar-driven refrigeration ejector system. Chemical Product and Process Modeling. 2024;19(1):69-80. doi:10.1515/cppm-2023-0042

BibTeX
@article{Cong2024,
  author = {Cong, Honglun and Zhang, Jiao},
  title = {Numerical investigation of the effects of dry gas model and wet steam model in solar-driven refrigeration ejector system},
  journal = {Chemical Product and Process Modeling},
  year = {2024},
  volume = {19},
  number = {1},
  pages = {69--80},
  doi = {10.1515/cppm-2023-0042}
}
Kostenlos starten →