EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 3.0

Design Of Hollow Section Overlap Joints With The Reinforcing Rib Plate. Welded Connection Resistance

J. Bródka, M. Broniewicz

Archives of Civil Engineering · 2015

DOI: 10.1515/ace-2015-0002 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Archives of Civil Engineering, 2015. Verfasst von J. Bródka und 1 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 1 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 3.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In calculating the resistance of welds within the connections between hollow sections in EN 1993-1-8, very general information is given without presenting specific calculations. The chief recommendations indicate that the resistance of the welds connecting the wall to the second element should not be less than the resistance of the cross section of the wall. In addition, assessment of the welds’ resistance based on the effective lengths is viable in cases when forces in the braces are smaller than the resistance of the joint, though the detailed method was not specified. The objective of this paper is to present the most up-to-date information about the design of overlap welded joints with a reinforcing rib plate.

Zitieren

APA

Bródka, J., & Broniewicz, M. (2015). Design Of Hollow Section Overlap Joints With The Reinforcing Rib Plate. Welded Connection Resistance. Archives of Civil Engineering. https://doi.org/10.1515/ace-2015-0002

Vancouver

Bródka J, Broniewicz M. Design Of Hollow Section Overlap Joints With The Reinforcing Rib Plate. Welded Connection Resistance. Archives of Civil Engineering. 2015. doi:10.1515/ace-2015-0002

BibTeX
@article{Brdka2015,
  author = {Bródka, J. and Broniewicz, M.},
  title = {Design Of Hollow Section Overlap Joints With The Reinforcing Rib Plate. Welded Connection Resistance},
  journal = {Archives of Civil Engineering},
  year = {2015},
  doi = {10.1515/ace-2015-0002}
}
Kostenlos starten →