EUVIMEDEUVIMED entdecken
VergleichsstudieOpen Access · CC BY 4.0

Analysis of osseodensification with two drill systems versus conventional technique for dental implants –A paired comparative ex vivo study

Rafaela Regina de Lima iD, Lara Rúbia Marques Nascimento, Barbara Magalhães Figueiredo Dias, Dhelfeson Willya Douglas-de-Oliveira, Rodrigo Richard da Silveira, Frederico Santos Lages

PLOS One · 2026

DOI: 10.1371/journal.pone.0338078 ↗

Kurz gefasst

Vergleichsstudie in der Zeitschrift PLOS One, 2026. Verfasst von Rafaela Regina de Lima und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Restorative Dentistry, Faculty of Dentistry, Federal University of Minas Gerais, Belo Horizonte, Minas Gerais, Brazil. Hauptthemen laut MEDLINE: Dental Implants, Osseointegration, Dental Implantation, Endosseous. Die Arbeit nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundação de Amparo à Pesquisa do Estado de Minas Gerais, Coordenação de Aperfeiçoamento de Pessoal de Nível Superior, Pró-Reitoria de Pesquisa, Universidade Federal de Minas Gerais.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Objective

To compare conventional and osseodensification techniques assessing insertion/removal torque, stability (ISQ), maximum temperature, and bone structural alterations, as well as evaluating the performance of osseodensification with two bur systems: Densah®/Versah and Bone Reamer Drills®/WF.

Methods

Sixteen bovine ribs were prepared into standardized samples. Each bone block received three osteotomies using different techniques following manufacturers’ protocols: G1 – conventional burs; G2 – osseodensification with Densah®/Versah burs (VS); G3 – osseodensification with Bone Reamer Drills®/WF burs. Osteotomies were performed under irrigation with 0.9% saline at 4–6 °C. Heat generation was recorded with a thermocouple; torque was measured at implant insertion and removal; ISQ was obtained after implant insertion using Osstell ISQ positioned 2 mm from the SmartPeg at a 45º angle. The burs were weighed before and after perforations and analyzed by scanning electron microscopy (SEM). Bone samples also underwent SEM analysis after implant removal.

Results

The osseodensification groups exhibited increased insertion and removal torque values and bone compaction at the implant interface was observed. There was no significant increases in ISQ or maximum temperature compared to conventional drilling. No significant mass loss was observed in either systems.

Conclusion

Bone instrumentation with both osseodensification kits improved primary implant stability, demonstrating higher insertion and removal torque values than conventional drilling in type IV bone. No significant ISQ and temperature differences were found. SEM revealed compacted bone at the implant interface in the osseodensification groups. No significant mass changes were observed. Clinical relevance Results suggest that both techniques are safe and effective for clinical recommendation.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Dental ImplantsOsseointegrationDental Implantation, EndosseousAnimalsCattleTorqueRibsOsteotomy

Substanzen

Dental Implants

Autor:innen und Institutionen

  • Department of Restorative Dentistry, Faculty of Dentistry, Federal University of Minas Gerais, Belo Horizonte, Minas Gerais, Brazil.
  • Department of Dentistry, Federal University of Vales do Jequitinhonha e Mucuri, JK Campus, Diamantina, Minas Gerais, Brazil.

ORCID-Profile: Rafaela Regina de Lima

Förderung

  • Fundação de Amparo à Pesquisa do Estado de Minas Gerais
  • Coordenação de Aperfeiçoamento de Pessoal de Nível Superior
  • Pró-Reitoria de Pesquisa, Universidade Federal de Minas Gerais

Zitieren

APA

de Lima, R. R., Nascimento, L. R. M., Dias, B. M. F., Douglas-de-Oliveira, D. W., da Silveira, R. R., & Lages, F. S. (2026). Analysis of osseodensification with two drill systems versus conventional technique for dental implants –A paired comparative ex vivo study. PLOS One. https://doi.org/10.1371/journal.pone.0338078

Vancouver

de Lima RR, Nascimento LRM, Dias BMF, Douglas-de-Oliveira DW, da Silveira RR, Lages FS. Analysis of osseodensification with two drill systems versus conventional technique for dental implants –A paired comparative ex vivo study. PLOS One. 2026. doi:10.1371/journal.pone.0338078

BibTeX
@article{deLima2026,
  author = {de Lima, Rafaela Regina and Nascimento, Lara Rúbia Marques and Dias, Barbara Magalhães Figueiredo and Douglas-de-Oliveira, Dhelfeson Willya and da Silveira, Rodrigo Richard and Lages, Frederico Santos},
  title = {Analysis of osseodensification with two drill systems versus conventional technique for dental implants –A paired comparative ex vivo study},
  journal = {PLOS One},
  year = {2026},
  doi = {10.1371/journal.pone.0338078}
}
Kostenlos starten →