Study on the damage constitutive characteristics of coal-rock composites under uniaxial compression: Influence of prefabricated crack angle and geometric dimensions
PLOS ONE · 05.03.2025 · 20 (3) · e0316586
DOI: 10.1371/journal.pone.0316586 ↗Kurz gefasst
Fachartikel in der Zeitschrift PLOS ONE, online erschienen am 05.03.2025. Verfasst von Qingwen Li und 6 weiteren Autor:innen. Beteiligte Einrichtung: School of Civil and Architectural Engineering, Liaoning University of Technology, Jinzhou, China. Hauptthemen laut MEDLINE: Coal. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 52 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: General Project of Liaoning Provincial Natural Science Foundation, Basic Scientific Research Upper Level Project, Project of Liaoning Provincial Doctoral Research Start-up Fund.
Abstract (Originalsprache)
In coal mining environments with complex topographic and geological conditions, the presence of primary cracks in the rock strata of the upper mining airspace is critical to mine safety, especially when roof slabs are broken. Cracked roof slabs not only increase risks during mining but also make mining operations more challenging. Therefore, studying the initial damage state of the roof rock formation is great significance. In this study, the effects of different prefabricated crack sizes and inclination angles on the mechanical properties of the coal-rock composite containing cracks were analyzed through the uniaxial compression experiments and PFC 2D numerical simulations. The results show that the peak strength and elastic modulus of the coal-rock composites fall between those of pure coal and sandstone, while the macroscopic mechanical parameters of crack-containing composites are significantly lower than those of non-crack-containing composites. Coal-rock composites with different crack characteristics exhibited different mechanical properties, with their damage modes were caused by the combined effects of tensile and shear damage. The increase in crack inclination altered the crack extension path, and the final damage of the specimen manifested first in the upper part, then the middle part, and ultimately in the lower part of the coal body, with tension-induced bulk damage being the dominant failure mode. Analysis of the radial cumulative map revealed that cracks primarily extended along 90° and 270° directions, indicating a strong tendency for crack propagation under axial pressure. The damage evolution curves indicate a nonlinear relationship between the damage factor and strain. While increased crack inclination enhances the compressive performance of coal-rock composites, it simultaneously accelerates structural destabilization. These findings offer theoretical insights into the damage mechanisms of coal-rock composites with cracks, serving as valuable references for coal mining safety.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Autor:innen und Institutionen
- School of Civil and Architectural Engineering, Liaoning University of Technology, Jinzhou, China.
ORCID-Profile: Qingwen Li, Chuangchuang Pan
Förderung
- General Project of Liaoning Provincial Natural Science Foundation
- Basic Scientific Research Upper Level Project
- Project of Liaoning Provincial Doctoral Research Start-up Fund
- Guiding Project of Liaoning Province Natural Science Foundation
- The General Project of Liaoning Provincial Natural Science Foundation
- Liaoning Provincial Department of Education Basic Scientific Research Upper Level Project
Zitieren
APA
Li, Q., Pan, C., Zhong, Y., Li, W., Li, L., Nie, F., & Chen, J. (2025). Study on the damage constitutive characteristics of coal-rock composites under uniaxial compression: Influence of prefabricated crack angle and geometric dimensions. PLOS ONE, 20(3), e0316586. https://doi.org/10.1371/journal.pone.0316586
Vancouver
Li Q, Pan C, Zhong Y, Li W, Li L, Nie F, et al. Study on the damage constitutive characteristics of coal-rock composites under uniaxial compression: Influence of prefabricated crack angle and geometric dimensions. PLOS ONE. 2025;20(3):e0316586. doi:10.1371/journal.pone.0316586
BibTeX
@article{Li2025,
author = {Li, Qingwen and Pan, Chuangchuang and Zhong, Yuqi and Li, Wenxia and Li, Ling and Nie, Fanfan and Chen, Jiabo},
title = {Study on the damage constitutive characteristics of coal-rock composites under uniaxial compression: Influence of prefabricated crack angle and geometric dimensions},
journal = {PLOS ONE},
year = {2025},
volume = {20},
number = {3},
pages = {e0316586},
doi = {10.1371/journal.pone.0316586}
}
EUVIMED