EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Capabilities of incremental forming of thin-walled products using a universal numerically controlled machine based on numerical simulations

Jarosław Wójcik, Janusz Tomczak, Tomasz Kusiak

Advances in Science and Technology Research Journal · 01.07.2026 · 20 (7) · 494-504

DOI: 10.12913/22998624/219862 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advances in Science and Technology Research Journal, online erschienen am 01.07.2026. Verfasst von Jarosław Wójcik und 2 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Due to the lack of universal machines on the market, this paper presents a new technology and a dedicated machine for manufacturing sheet metal products with various geometries using a single set of tools. The study reports the results of numerical simulations of incremental forming of thin-walled products. The numerical analysis was per - formed on S355 steel sheets with thicknesses ranging from 1 to 5 mm. The bending line followed an arc-shaped trajectory. In the analyzed process, the sheet was deformed using two rollers: a shaping roller and a support roller. Simulations were carried out using Simufact Forming software. Process force parameters, as well as strain and stress distributions, were determined. The maximum forming forces obtained from the numerical simulations ranged from 2 kN for a sheet thickness of 1 mm to 24.5 kN for the maximum analyzed thickness of 5 mm. Pre - liminary numerical simulations indicate that wrinkling may occur in sheets with thicknesses of 1 mm and 2 mm , whereas for thicker sheets this instability was not observed in the simulations . The maximum effective plastic strain recorded for the 5 mm sheet was 1.15, while the maximum von Mises stress reached 724 MPa. Based on the simulation results, it can be stated that the proposed technology shows potential for industrial applications, particularly for single-unit production and prototyping. However, experimental validation is required.

Zitieren

APA

Wójcik, J., Tomczak, J., & Kusiak, T. (2026). Capabilities of incremental forming of thin-walled products using a universal numerically controlled machine based on numerical simulations. Advances in Science and Technology Research Journal, 20(7), 494-504. https://doi.org/10.12913/22998624/219862

Vancouver

Wójcik J, Tomczak J, Kusiak T. Capabilities of incremental forming of thin-walled products using a universal numerically controlled machine based on numerical simulations. Advances in Science and Technology Research Journal. 2026;20(7):494-504. doi:10.12913/22998624/219862

BibTeX
@article{Wjcik2026,
  author = {Wójcik, Jarosław and Tomczak, Janusz and Kusiak, Tomasz},
  title = {Capabilities of incremental forming of thin-walled products using a universal numerically controlled machine based on numerical simulations},
  journal = {Advances in Science and Technology Research Journal},
  year = {2026},
  volume = {20},
  number = {7},
  pages = {494--504},
  doi = {10.12913/22998624/219862}
}
Kostenlos starten →