EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Evaluating material-extrusion additive manufacturing for hydrodynamic clutch rotor prototypes

Wojciech Iwanicki, Jarosław Kotliński, Karol Osowski, Artur Olszak, Ireneusz Musiałek, Karol Musiałek, Zbigniew Kęsy, Andrzej Kęsy

Advances in Science and Technology Research Journal · 01.05.2026 · 20 (5) · 239-253

DOI: 10.12913/22998624/216249 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Advances in Science and Technology Research Journal, online erschienen am 01.05.2026. Verfasst von Wojciech Iwanicki und 7 weiteren Autor:innen. Die Arbeit wurde bisher 1-mal zitiert (Crossref). Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The article presents the results of numerical calculations examining the influence of channel roughness in a hydro - dynamic clutch on the transmitted torque. Additionally, the study reports measurements of surface roughness and dimensional deviations of hydrodynamic clutch rotors. The rotors were manufactured using 3D printing based on material extrusion (MEX) technology and produced from three different materials: PLA, ABS, and PET-G. Based on the analysis of the obtained measurement and calculation results, the suitability of the MEX technology for manufacturing hydrodynamic clutch rotor prototypes is assessed. The results indicate that the surface roughness of the printed rotors is comparable to that of rotors produced by casting or machining. Moreover, the dimensional accuracy of the printed rotors lies within the tolerance range specified in the design of hydrodynamic clutch rotors. The article concludes with findings indicating that the adopted modeling and manufacturing procedure, employing the MEX technology, can be applied to produce hydrodynamic clutch rotor prototypes.

Zitieren

APA

Iwanicki, W., Kotliński, J., Osowski, K., Olszak, A., Musiałek, I., Musiałek, K., Kęsy, Z., & Kęsy, A. (2026). Evaluating material-extrusion additive manufacturing for hydrodynamic clutch rotor prototypes. Advances in Science and Technology Research Journal, 20(5), 239-253. https://doi.org/10.12913/22998624/216249

Vancouver

Iwanicki W, Kotliński J, Osowski K, Olszak A, Musiałek I, Musiałek K, et al. Evaluating material-extrusion additive manufacturing for hydrodynamic clutch rotor prototypes. Advances in Science and Technology Research Journal. 2026;20(5):239-253. doi:10.12913/22998624/216249

BibTeX
@article{Iwanicki2026,
  author = {Iwanicki, Wojciech and Kotliński, Jarosław and Osowski, Karol and Olszak, Artur and Musiałek, Ireneusz and Musiałek, Karol and Kęsy, Zbigniew and Kęsy, Andrzej},
  title = {Evaluating material-extrusion additive manufacturing for hydrodynamic clutch rotor prototypes},
  journal = {Advances in Science and Technology Research Journal},
  year = {2026},
  volume = {20},
  number = {5},
  pages = {239--253},
  doi = {10.12913/22998624/216249}
}
Kostenlos starten →