DEVELOPMENT OF CYCLIC SLIP BANDS IN UFG COPPER IN GIGACYCLE FATIGUE
Acta Metallurgica Slovaca · 2013
DOI: 10.12776/ams.v19i2.92 ↗Kurz gefasst
Fachartikel in der Zeitschrift Acta Metallurgica Slovaca, 2013. Verfasst von Lucie Navrátilová. Die Arbeit wurde bisher 6-mal zitiert (Crossref).
Abstract (Originalsprache)
Ultrafine-grained (UFG) copper studied in this paper was produced by equal channel angularpressing (ECAP) method and tested in gigacycle fatigue region. In contrary to conventionalgrain size copper, the appearance of cyclic slip bands is quite rare and surface relief does notform well below the fatigue limit. The cyclic slip bands develop in regions of near-by orientedgrains, where the neighbouring grains have very simmilar disorientation. Length of the cyclicslip bands substantially exceeds the average grain size of UFG Cu. No grain coarsening due tocycling was observed. Development of damage, which finally results in fatigue crack initiation,was observed below the surface relief.
Zitieren
APA
Navrátilová, L. (2013). DEVELOPMENT OF CYCLIC SLIP BANDS IN UFG COPPER IN GIGACYCLE FATIGUE. Acta Metallurgica Slovaca. https://doi.org/10.12776/ams.v19i2.92
Vancouver
Navrátilová L. DEVELOPMENT OF CYCLIC SLIP BANDS IN UFG COPPER IN GIGACYCLE FATIGUE. Acta Metallurgica Slovaca. 2013. doi:10.12776/ams.v19i2.92
BibTeX
@article{Navrtilov2013,
author = {Navrátilová, Lucie},
title = {DEVELOPMENT OF CYCLIC SLIP BANDS IN UFG COPPER IN GIGACYCLE FATIGUE},
journal = {Acta Metallurgica Slovaca},
year = {2013},
doi = {10.12776/ams.v19i2.92}
}
EUVIMED