EUVIMEDEUVIMED entdecken
Crossref

Toward low-impact sources for near-surface characterization

Aparajita Nath, Florencia Balestrini, Angus Ogilvie, Johannes Singer, Vsevolod Kovalenko, Rik Wemmenhove

The Leading Edge · 01.07.2026 · 45 (7) · 514-523

DOI: 10.1190/tle-2025-1028 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The Leading Edge, online erschienen am 06.07.2026. Verfasst von Aparajita Nath und 5 weiteren Autor:innen. Die Arbeit nennt 18 Literaturangaben. Gefördert von: Rijksdienst voor Ondernemend Nederland.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Conventional seismic sources, such as airguns, dynamite, and hammers/thumpers, produce high-amplitude signals that are unsuitable for use in areas with structural sensitivity or within marine protected areas (MPAs) due to their environmental impact. As a remedy, low-impact sources emitting long, deterministic, noise-like signatures offer a promising alternative. These signals not only reduce peak amplitudes but also provide technical advantages such as spectral shaping, amplitude control, repeatability, and the ability to multiplex sources. In this study, the use of such deterministic noise-like signatures was explored through a series of proof-of-concept trials using commercially available low-impact sources. The target was near-surface seismic characterization, focusing on the shallow structural and geotechnical properties. Electric vibrators and underwater transducers were tested across three environments, i.e., land, lake, and offshore, to evaluate their performance and environmental impact. The land trial demonstrated that pseudorandom binary sequences emitted by an electric vibrator could generate clear surface-wave dispersion curves with significantly lower particle velocities than traditional hammer sources. In the lake trial, an underwater transducer produced seismic signals with amplitudes up to 35 dB lower than a small airgun (5 cubic inches) while still delivering comparable signal-to-noise ratio data quality. The offshore trial showed that the same transducer could acquire ultra-high resolution data, like 2D seismic data, across a broad frequency range (200–1000 Hz) in MPAs where impulsive sources are restricted. A fast-track processing workflow that enables effective signal recovery and imaging using these continuous sources was also proposed. The findings confirmed that low-impact, deterministic sources are a viable and environmentally responsible alternative for near-surface seismic investigations, particularly in sensitive or regulated areas.

Förderung

  • Rijksdienst voor Ondernemend Nederland

Zitieren

APA

Nath, A., Balestrini, F., Ogilvie, A., Singer, J., Kovalenko, V., & Wemmenhove, R. (2026). Toward low-impact sources for near-surface characterization. The Leading Edge, 45(7), 514-523. https://doi.org/10.1190/tle-2025-1028

Vancouver

Nath A, Balestrini F, Ogilvie A, Singer J, Kovalenko V, Wemmenhove R. Toward low-impact sources for near-surface characterization. The Leading Edge. 2026;45(7):514-523. doi:10.1190/tle-2025-1028

BibTeX
@article{Nath2026,
  author = {Nath, Aparajita and Balestrini, Florencia and Ogilvie, Angus and Singer, Johannes and Kovalenko, Vsevolod and Wemmenhove, Rik},
  title = {Toward low-impact sources for near-surface characterization},
  journal = {The Leading Edge},
  year = {2026},
  volume = {45},
  number = {7},
  pages = {514--523},
  doi = {10.1190/tle-2025-1028}
}
Kostenlos starten →