Physical and Dosimetric Characterization of Silicone Rubber Bolus for Head Photon-Beam Radiotherapy
Technology in Cancer Research & Treatment · 2024
DOI: 10.1177/15330338241293267 ↗Kurz gefasst
Fachartikel in der Zeitschrift Technology in Cancer Research & Treatment, 2024. Verfasst von Xuemei Chen und 8 weiteren Autor:innen. Beteiligte Einrichtung: State Key Laboratory of Oncology in South China, Guangdong Provincial Clinical Research Center for Cancer, Sun Yat-sen University Cancer Center, Guan…. Hauptthemen laut MEDLINE: Silicone Elastomers, Radiotherapy Dosage, Radiotherapy Planning, Computer-Assisted, Phantoms, Imaging. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 23 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: hanghai United Imaging Healthcare Co., Ltd., Special Scientific Research Fund for Medical Physics & Technology of Guangdong Biomedical Engineering Society, Guangdong Basic and Applied Basic Research Foundation.
Abstract (Originalsprache)
Objective
This study assesses the physical properties of the silicone rubber (SR) bolus, compares its dosimetric characterization with those of gel and thermoset boluses, aiming to evaluate the feasibility and stability of utilizing SR bolus for head photon-beam radiotherapy.
Methods
Three types of boluses (gel, thermoset, and SR) were prepared with same dimensions. Firstly, the physical properties of SR bolus (density, tensile strength and hardness) were assessed pre-irradiation and post-irradiation. Secondly, the percentage of depth dose (PDD) curve was calculated using the treatment planning system (TPS) and measured with a plane-parallel. Thirdly, these three boluses were individually placed on the head phantom, followed by computed tomography (CT) scans to delineate the customized target area and organs at risk (OARs) for treatment planning. Over the subsequent three weeks, fan-beam CT (FBCT) images were obtained weekly and registered with the initial CT to modify the target area and OARs. Fourthly, the adhesion differences, dose distributions, and inter-fraction reproducibility of the three boluses were compared and evaluated.
Results
The results observed that post-irradiated SR bolus exhibited higher hardness values ( p < .01) than the pre-irradiated one, with no significant differences in tensile strength and density. The PDD curves of all three boluses showed similarity within a difference range less than ±1%. The air gaps between the SR, thermoset, and gel boluses and skin surfaces were measured as 0.07 cm 3 , 2.96 cm 3 , and 4.82 cm 3 , respectively. Compared with gel bolus and thermoset bolus, the SR bolus demonstrated noticeable inter-fraction reproducibility.
Conclusion
The SR bolus can be fabricated at room temperature, adheres to irregular body surfaces, and retains its physical properties post-irradiation. Additionally, this bolus has comparable dosimetric characterization to other commercial boluses, and may provide notable protection for OARs. Therefore, the SR bolus is recommended as a feasible and stable material for head photon-beam radiotherapy.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- State Key Laboratory of Oncology in South China, Guangdong Provincial Clinical Research Center for Cancer, Sun Yat-sen University Cancer Center, Guangzhou, P. R. China.
- Shenzhen United Imaging Research Institute of Innovative Medical Equipment, Shenzhen, Guangdong Province, China.
ORCID-Profile: Xuemei Chen, Bin Li
Förderung
- hanghai United Imaging Healthcare Co., Ltd.
- Special Scientific Research Fund for Medical Physics & Technology of Guangdong Biomedical Engineering Society
- Guangdong Basic and Applied Basic Research Foundation
Zitieren
APA
Chen, X., Wang, W., Huang, X., Diao, W., Xu, C., Jia, L., Li, H., Li, B., & Jiang, X. (2024). Physical and Dosimetric Characterization of Silicone Rubber Bolus for Head Photon-Beam Radiotherapy. Technology in Cancer Research & Treatment. https://doi.org/10.1177/15330338241293267
Vancouver
Chen X, Wang W, Huang X, Diao W, Xu C, Jia L, et al. Physical and Dosimetric Characterization of Silicone Rubber Bolus for Head Photon-Beam Radiotherapy. Technology in Cancer Research & Treatment. 2024. doi:10.1177/15330338241293267
BibTeX
@article{Chen2024,
author = {Chen, Xuemei and Wang, Wei and Huang, Xiaotong and Diao, Wenchao and Xu, Chendi and Jia, Lecheng and Li, Hua and Li, Bin and Jiang, Xiaobo},
title = {Physical and Dosimetric Characterization of Silicone Rubber Bolus for Head Photon-Beam Radiotherapy},
journal = {Technology in Cancer Research & Treatment},
year = {2024},
doi = {10.1177/15330338241293267}
}
EUVIMED