Sensing the concentration and quantity of sodium chloride solution on asphalt using near infrared spectroscopy
Journal of Near Infrared Spectroscopy · 19.11.2026
DOI: 10.1177/09670335261505098 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Near Infrared Spectroscopy, online erschienen am 19.11.2026. Verfasst von Wei Zhang und 2 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: EU Interreg Sweden-Norway.
Abstract (Originalsprache)
To keep winter roads safe, chemical agents are normally applied for de-icing and anti-icing purposes. Smarter and more precise spreading that accounts for local concentration variations can lower the total amount required. This paper describes an optical chemometric sensor that measures both the concentration and the mass of sodium chloride (NaCl) solution on road surfaces. Experiments were carried out in an indoor laboratory environment, where NaCl solutions of seven different concentrations were poured onto a diffusely reflecting asphalt surface. Short-wave infrared light was directed onto the surface with an angle of incidence of 25° to suppress the specular reflection on the liquid layer surface, and after a double pass through the liquid layer the diffusely reflected light was collected by a spectrometer. Background subtraction isolates the absorption caused only by the liquid, so that the pure absorbance spectra could be modelled with a Beer-Lambert based approach. An overdetermined equation system, augmented by a bias term to account for residual baseline offset, yields simultaneous estimates of concentration and liquid amount. For the 21 averaged spectra, the RMSE was 2.6% for salinity and 23.3 g/m 2 for solution quantity before post-calibration. Empirical linear post-calibration reduced the corresponding RMSE values to 1.4% and 18.2 g/m 2 , respectively. The distinct properties of various asphalt types and chemicals, the suppression of ambient light, complex environmental variables such as temperature, humidity, and wind, and the low signal-to-noise ratio problem are the challenges for future chemometric sensing of outdoor asphalt pavement.
Förderung
- EU Interreg Sweden-Norway
Zitieren
APA
Zhang, W., Thörnberg, B., & Klein-Paste, A. (2026). Sensing the concentration and quantity of sodium chloride solution on asphalt using near infrared spectroscopy. Journal of Near Infrared Spectroscopy. https://doi.org/10.1177/09670335261505098
Vancouver
Zhang W, Thörnberg B, Klein-Paste A. Sensing the concentration and quantity of sodium chloride solution on asphalt using near infrared spectroscopy. Journal of Near Infrared Spectroscopy. 2026. doi:10.1177/09670335261505098
BibTeX
@article{Zhang2026,
author = {Zhang, Wei and Thörnberg, Benny and Klein-Paste, Alex},
title = {Sensing the concentration and quantity of sodium chloride solution on asphalt using near infrared spectroscopy},
journal = {Journal of Near Infrared Spectroscopy},
year = {2026},
doi = {10.1177/09670335261505098}
}
EUVIMED