Multi-response optimization on abrasive water jet machining of Aluminum 7075 alloy using Taguchi–DEAR methodology
Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering · 2024-12 · 238 (6) · 2691-2699
DOI: 10.1177/09544089231163724 ↗Kurz gefasst
Fachartikel in der Zeitschrift Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, online erschienen am 20.03.2023. Verfasst von Ayyagounder Shanmugam und 4 weiteren Autor:innen. Die Arbeit wurde bisher 9-mal zitiert (Crossref) und nennt 49 Literaturangaben.
Abstract (Originalsprache)
This research aims to conduct the multi-response optimization for abrasive water jet machining (AWJM) of Aluminum 7075 metal matrix composites. The experiments were conducted with three levels of AWJM factors such as pressure, standoff distance, and traverse speed. The experiments were designed using Taguchi's L 9 orthogonal array. The influence of AWJM parameters was assessed by measuring the outcomes like material removal rate, surface roughness, and taper angle. The single response optimization was obtained through Taguchi's signal-to-noise ratio analysis, and multi-response optimization was achieved with Taguchi–data envelopment analysis-based ranking (DEAR). From DEAR, the optimal AWJM parameter 180 MPa of pressure, 3 mm of standoff distance, and 40 mm/min traverse speed was found. After optimization, the surface roughness and taper angle were reduced by 5.44% and 10.92%, respectively. The influence of cutting parameters on the outcomes was examined through the analysis of variance. It was noted that traverse speed had a significant effect and a contribution of 47.79%. After AWJM, the surface was evaluated using SEM analysis, ploughing marks, ductile rupture, and a small crack were observed.
Zitieren
APA
Shanmugam, A., Mohanraj, T., Krishnamurthy, K., Gur, A. K., & Caligulu, U. (2024). Multi-response optimization on abrasive water jet machining of Aluminum 7075 alloy using Taguchi–DEAR methodology. Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, 238(6), 2691-2699. https://doi.org/10.1177/09544089231163724
Vancouver
Shanmugam A, Mohanraj T, Krishnamurthy K, Gur AK, Caligulu U. Multi-response optimization on abrasive water jet machining of Aluminum 7075 alloy using Taguchi–DEAR methodology. Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering. 2024;238(6):2691-2699. doi:10.1177/09544089231163724
BibTeX
@article{Shanmugam2024,
author = {Shanmugam, Ayyagounder and Mohanraj, Thangamuthu and Krishnamurthy, Kasilingam and Gur, Ali Kaya and Caligulu, Ugur},
title = {Multi-response optimization on abrasive water jet machining of Aluminum 7075 alloy using Taguchi–DEAR methodology},
journal = {Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering},
year = {2024},
volume = {238},
number = {6},
pages = {2691--2699},
doi = {10.1177/09544089231163724}
}
EUVIMED