Eliminating eccentricity error in measuring residual stresses via hole-drilling method using strain gauge rosette with five measuring grids: For thin plates using through-holes
The Journal of Strain Analysis for Engineering Design · 2024-10 · 59 (7) · 475-490
DOI: 10.1177/03093247241262178 ↗Kurz gefasst
Fachartikel in der Zeitschrift The Journal of Strain Analysis for Engineering Design, online erschienen am 26.07.2024. Verfasst von Ying Gu und 5 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 24 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Sichuan Science and Technology Program.
Abstract (Originalsprache)
In the measurement of residual stresses (RSs) via the hole-drilling method, the error induced by the eccentricity of the drilled hole is inevitable and non-negligible in some cases. In this study, both the eccentricity coordinates and RS state (two principal stresses and one principal angle) are considered unknowns that must be solved. A set of five equations is required to determine these five unknowns. Therefore, two additional measuring grids are added to the strain gauge comprising three grids, which is typically used in measuring RSs. Consequently, a novel strain gauge rosette with five measuring grids (SGR-5MG) is created. Subsequently, an algorithm associated with the SGR-5MG is developed to solve the five unknowns based on the Newton–Raphson method. The algorithm is elasticity-based and derived according to the layout of the SGR-5MG. Finally, the proposed method is verified numerically and experimentally. The results show that (1) the eccentricity error is up to 35.1% when the eccentricity reaches 0.05 D, where D represents the diameter of the gauge circle; (2) Using the proposed method, the error can be significantly reduced to 7.2%; (3) The elasticity-based proposed method cannot make the predicted results exactly converge to the actual stresses in predicting high stresses because of the plasticity deformation around the hole. The eccentricity error can be reduced significantly by using the proposed method based on the SGR-5MG.
Förderung
- National Natural Science Foundation of China
- Sichuan Science and Technology Program
Zitieren
APA
Gu, Y., Chen, J., Gu, S., Kong, C., Ren, S., & Du, Y. (2024). Eliminating eccentricity error in measuring residual stresses via hole-drilling method using strain gauge rosette with five measuring grids: For thin plates using through-holes. The Journal of Strain Analysis for Engineering Design, 59(7), 475-490. https://doi.org/10.1177/03093247241262178
Vancouver
Gu Y, Chen J, Gu S, Kong C, Ren S, Du Y. Eliminating eccentricity error in measuring residual stresses via hole-drilling method using strain gauge rosette with five measuring grids: For thin plates using through-holes. The Journal of Strain Analysis for Engineering Design. 2024;59(7):475-490. doi:10.1177/03093247241262178
BibTeX
@article{Gu2024,
author = {Gu, Ying and Chen, Jiaojiao and Gu, Song and Kong, Chao and Ren, Songbo and Du, Yixiang},
title = {Eliminating eccentricity error in measuring residual stresses via hole-drilling method using strain gauge rosette with five measuring grids: For thin plates using through-holes},
journal = {The Journal of Strain Analysis for Engineering Design},
year = {2024},
volume = {59},
number = {7},
pages = {475--490},
doi = {10.1177/03093247241262178}
}
EUVIMED