EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

A study on a 3D morphological measurement method for tobacco stems based on point cloud data and central skeleton extraction

Wenxia Kong, Chunyuan Zhao, Hai Zhu, Xiaofeng Zhang, Xiaoyan Shen

Measurement and Control · 14.05.2026

DOI: 10.1177/00202940261448671 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Measurement and Control, online erschienen am 14.05.2026. Verfasst von Wenxia Kong und 4 weiteren Autor:innen. Die Arbeit nennt 26 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Conventional two-dimensional image-based methods are limited in measuring the three-dimensional morphology of tobacco stems, especially thickness and curved geometry. This study proposes a point-cloud-based method for three-dimensional tobacco stem measurement using a dual-laser scanning system. The method combines improved centerline skeleton extraction, upper–lower surface registration, and skeleton-guided cross-sectional analysis to estimate length, width, thickness, and fineness. Adaptive neighborhood re-weighting and curvature-constrained regularization are introduced to improve skeleton extraction, and reference-assisted registration is used to support thickness measurement. For a standard gauge block, the proposed method achieved mean absolute errors below 0.009 mm and root mean square errors below 0.011 mm for length, width, and thickness measurements. Validation on 30 tobacco stem samples showed good agreement with the YC image-based method for length and width, with correlation coefficients of 0.998 and 0.997, respectively. The results demonstrate the feasibility of thickness-aware three-dimensional morphological measurement of tobacco stems under the tested conditions.

Zitieren

APA

Kong, W., Zhao, C., Zhu, H., Zhang, X., & Shen, X. (2026). A study on a 3D morphological measurement method for tobacco stems based on point cloud data and central skeleton extraction. Measurement and Control. https://doi.org/10.1177/00202940261448671

Vancouver

Kong W, Zhao C, Zhu H, Zhang X, Shen X. A study on a 3D morphological measurement method for tobacco stems based on point cloud data and central skeleton extraction. Measurement and Control. 2026. doi:10.1177/00202940261448671

BibTeX
@article{Kong2026,
  author = {Kong, Wenxia and Zhao, Chunyuan and Zhu, Hai and Zhang, Xiaofeng and Shen, Xiaoyan},
  title = {A study on a 3D morphological measurement method for tobacco stems based on point cloud data and central skeleton extraction},
  journal = {Measurement and Control},
  year = {2026},
  doi = {10.1177/00202940261448671}
}
Kostenlos starten →