EUVIMEDUpptäck EUVIMED
Crossref

The Impact of Oxygen Concentration on the Postcuring of 3D-Printed Dental Resin

Da Sol Han, Reuben Kim, Hong-Keun Hyun, Hyung-In Yoon, Ha Rim Jeong, Seol Hee Jeon, Chan Park

International Journal of Prosthodontics · 2024

DOI: 10.11607/ijp.8919 ↗

At a glance

Journal article in International Journal of Prosthodontics, 2024. Written by Da Sol Han and 6 co-authors. Major MEDLINE topics: Printing, Three-Dimensional, Water. Cited 12 times so far (Crossref).

AbstractSubjectsBibliografiska uppgifterCiteRelated studies

Abstract (original language)

PURPOSE: This study investigated the impact of reducing the oxygen concentration via nitrogen injection during the postcuring process of 3D-printed dental materials. MATERIALS AND METHODS: Resin specimens for dental crown and bridge (15-mm diameter, both 1-mm and 2-mm heights) were 3D-printed and rinsed. Subsequently, the postcuring process was conducted on nine groups categorized according to atmospheric conditions within the curing device (20% [control], 10%, and 5% oxygen) and curing times (10, 15, and 20 minutes). Surface roughness was measured using a gloss meter. Surface polymerization was confirmed through Fourier-transform infrared spectroscopy (FT-IR) analysis, and the flexural strength and elastic modulus of the specimens were measured using a universal testing machine. Water absorption and solubility were determined according to Inernational Organization for Standardization (ISO) standards. All evaluation criteria were statistically analyzed using one-way ANOVA and Tukey's post hoc test based on oxygen concentration. RESULTS: The elastic modulus did not show statistically significant differences in all groups. However, compared to the control group, the flexural strength, degree of conversion, and gloss significantly increased in the groups with decreased oxygen concentrations. Conversely, water solubility and water absorption significantly decreased in a few groups with reduced oxygen concentration. CONCLUSIONS: Reducing oxygen concentration through nitrogen injection during the postcuring process of 3D printing enhances the suitability of the dental prosthetic materials. The significant increase in flexural strength can particularly enhance the utility of these materials in dental prosthetics.

Subjects

MeSH terms (MEDLINE)

Printing, Three-DimensionalWaterSpectroscopy, Fourier Transform InfraredMaterials TestingPliabilityNitrogenResins, SyntheticSurface Properties

Substances

WaterNitrogenResins, Synthetic

Cite

APA

Han, D. S., Kim, R., Hyun, H. K., Yoon, H. I., Jeong, H. R., Jeon, S. H., & Park, C. (2024). The Impact of Oxygen Concentration on the Postcuring of 3D-Printed Dental Resin. International Journal of Prosthodontics. https://doi.org/10.11607/ijp.8919

Vancouver

Han DS, Kim R, Hyun HK, Yoon HI, Jeong HR, Jeon SH, et al. The Impact of Oxygen Concentration on the Postcuring of 3D-Printed Dental Resin. International Journal of Prosthodontics. 2024. doi:10.11607/ijp.8919

BibTeX
@article{Han2024,
  author = {Han, Da Sol and Kim, Reuben and Hyun, Hong-Keun and Yoon, Hyung-In and Jeong, Ha Rim and Jeon, Seol Hee and Park, Chan},
  title = {The Impact of Oxygen Concentration on the Postcuring of 3D-Printed Dental Resin},
  journal = {International Journal of Prosthodontics},
  year = {2024},
  doi = {10.11607/ijp.8919}
}
Start for free →