EUVIMEDSkopri EUVIMED
Open access · CC BY 4.0

Distal Upper Molar Force Distribution With Clear Aligners Using Different Anterior Teeth Anchorage Setups: A Finite Element Study

Weber Jose da Silva Ursi, Yamyle Claudia Velásquez Barragán, Ki Beom Kim, Carlos Flores-Mir iD, Guilherme de Araujo Almeida iD

Orthodontics & Craniofacial Research · 2026-04 · 29 (2) · 281-289

DOI: 10.1111/ocr.70077 ↗

At a glance

Journal article in Orthodontics & Craniofacial Research, published online on 2025-12-13. Written by Weber Jose da Silva Ursi and 4 co-authors. Institution: Department of Social and Clinical Pediatric Dentistry, Dental School of São Paulo State University, São José dos Campos, São Paulo, Brazil. Major MEDLINE topics: Tooth Movement Techniques, Orthodontic Anchorage Procedures, Molar, Orthodontic Appliance Design. Cited 1 times so far (Crossref); 23 references. The full text is freely available (open access, CC BY 4.0). Funded by: Coordenação de Aperfeiçoamento de Pessoal de Nível Superior, National Council for Scientific and Development (CNPq) - INCT Saúde Oral e Odontologia, Conselho Nacional de Desenvolvimento Científico e Tecnológico.

AstrattSubjectsDettalji biblijografiċiCiteRelated studies

Abstract (original language)

Objective

The notion that clear aligners alone can distalize upper molars without affecting anterior teeth is inaccurate. Although strategies such as Class II elastics, tooth‐movement sequencing, and attachment variations have been investigated to mitigate unwanted side effects, temporary anchorage devices have demonstrated potential for maintaining anchorage during molar distalization. This study used Finite Element Analysis to evaluate different setups for distalizing one or both upper molars, comparing passive anchorage (ligature tie) and active anchorage (1.66 N), and assessing the presence of vertical attachments. Materials and Methods Six models were generated with 0.2 mm distal activation for molar distalization. These models varied by premolar/M attachments and anchorage type—active (1.66 N) or passive—applied from extra‐alveolar screws to canine buttons.

Results

All setups distalized the second molars, but passive anchorage demonstrated greater efficiency and fewer side effects. Passive systems achieved over 90% distalization‐to‐anchorage loss ratios, compared with 65% with active forces. Passive setups also minimised unintended anterior movement and enabled distal canine movement following molars—an advantageous outcome. Vertical attachments had minimal impact. X ‐axis (midline) movement predominantly affected canines, particularly with active anchorage. Anterior intrusion on the Z ‐axis was reduced with passive systems.

Conclusion

Active anchorage forces may deform aligners and compromise control, whereas passive anchorage—similar to a ligature wire applied to anterior teeth—supports planned movement without disrupting biomechanics.

Subjects

MeSH terms (MEDLINE)

Tooth Movement TechniquesOrthodontic Anchorage ProceduresMolarOrthodontic Appliance DesignFinite Element AnalysisHumansBiomechanical PhenomenaCuspidDental Stress AnalysisMaxilla

Author keywords

clear alignersfinite element analysismolar distalizationskeletal anchorage

Authors and institutions

  • Department of Social and Clinical Pediatric Dentistry, Dental School of São Paulo State University, São José dos Campos, São Paulo, Brazil.
  • Post-Graduate Program of Dental School, Federal University of Uberlandia, Uberlandia, Minas Gerais, Brazil.
  • Dr. Lysle Johnston Endowed Chair in Orthodontics and the Program Director in the Orthodontic Department, Center for Advanced Dental Education, Saint Louis University, Saint Louis, Missouri, USA.
  • Department of Dentistry and Dental Hygiene, University of Alberta, Edmonton, Canada.
  • Department of Pediatric Dentistry and Orthodontics, Dental School of Federal University of Uberlandia, Uberlandia, Minas Gerais, Brazil.

ORCID profiles: Carlos Flores-Mir, Guilherme de Araujo Almeida

Funding

  • Coordenação de Aperfeiçoamento de Pessoal de Nível Superior
  • National Council for Scientific and Development (CNPq) - INCT Saúde Oral e Odontologia
  • Conselho Nacional de Desenvolvimento Científico e Tecnológico

Cite

APA

Ursi, W. J. D. S., Barragán, Y. C. V., Kim, K. B., Flores-Mir, C., & Almeida, G. A. (2026). Distal Upper Molar Force Distribution With Clear Aligners Using Different Anterior Teeth Anchorage Setups: A Finite Element Study. Orthodontics & Craniofacial Research, 29(2), 281-289. https://doi.org/10.1111/ocr.70077

Vancouver

Ursi WJDS, Barragán YCV, Kim KB, Flores-Mir C, Almeida GA. Distal Upper Molar Force Distribution With Clear Aligners Using Different Anterior Teeth Anchorage Setups: A Finite Element Study. Orthodontics & Craniofacial Research. 2026;29(2):281-289. doi:10.1111/ocr.70077

BibTeX
@article{Ursi2026,
  author = {Ursi, Weber Jose da Silva and Barragán, Yamyle Claudia Velásquez and Kim, Ki Beom and Flores-Mir, Carlos and Almeida, Guilherme de Araujo},
  title = {Distal Upper Molar Force Distribution With Clear Aligners Using Different Anterior Teeth Anchorage Setups: A Finite Element Study},
  journal = {Orthodontics & Craniofacial Research},
  year = {2026},
  volume = {29},
  number = {2},
  pages = {281--289},
  doi = {10.1111/ocr.70077}
}
Start for free →