Effects of low‐pressure plasma and ytterbium fiber laser on zirconia surface properties and bond strength to gingiva‐colored composite
Journal of Prosthodontics · 2026
DOI: 10.1111/jopr.70219 ↗Kurz gefasst
Vergleichsstudie in der Zeitschrift Journal of Prosthodontics, 2026. Verfasst von Merve Akbulut und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Prosthodontics, Gulhane Faculty of Dentistry, University of Health Sciences Turkey, Ankara, Turkey. Hauptthemen laut MEDLINE: Zirconium, Dental Bonding, Composite Resins, Dental Materials. Die Arbeit nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: University of Health Sciences Türkiye Research Foundation.
Abstract (Originalsprache)
Purpose
To evaluate and compare the effects of surface activation by low‐pressure plasma (LPP) and surface texturing by ytterbium fiber laser (YFL) treatments on zirconia surface properties and shear bond strength (SBS) to a gingiva‐colored indirect composite under aged and non‐aged conditions. Materials and Methods Sixty zirconia specimens were prepared, polished, sintered, and air‐abraded under standardized conditions. The specimens were randomly assigned to three groups according to the applied surface treatment: control, LPP, and YFL. Surface roughness and contact angle were measured before and after surface treatments. A gingiva‐colored indirect composite was bonded to the zirconia surfaces using an 10‐Methacryloyloxydecyl dihydrogen phosphate (MDP) containing primer and standardized mold. Each group was further divided into aged and non‐aged subgroups ( n = 10). Thermal aging was performed using thermocycling (5000 cycles, 5°C–55°C). SBS was measured, and failure modes were analyzed. Surface morphology, phase composition, and representative failure modes were evaluated using scanning electron microscopy (SEM) and X‐ray diffraction (XRD) analyses.
Results
Surface treatments influenced zirconia wettability, with LPP showing a greater reduction in contact angle compared to YFL. YFL groups exhibited higher SBS values than both LPP and control groups under both aged and non‐aged conditions. Thermal aging showed a significant overall effect on SBS, although no significant differences were observed between aged and non‐aged specimens within each surface treatment group. Failure modes were predominantly adhesive in low‐strength groups, whereas mixed failures were more frequent in high‐strength groups.
Conclusion
YFL enhanced bond strength at the zirconia and gingiva‐colored composite interface compared to LPP, whereas aging showed a small but significant overall effect on bond strength, with no significant interaction between aging and surface treatment.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Prosthodontics, Gulhane Faculty of Dentistry, University of Health Sciences Turkey, Ankara, Turkey.
- Department of Biomaterials, Hamidiye Institute of Health Sciences, University of Health Sciences Turkey, Istanbul, Turkey.
- Gulhane Medical Design and Manufacturing Center (METUM), University of Health Sciences Turkey, Ankara, Turkey.
- Department of Basic Medical Sciences, Gulhane Faculty of Dentistry, University of Health Sciences Turkey, Ankara, Turkey.
ORCID-Profile: Merve Akbulut, Ülkü Tuğba Kalyoncuoğlu, Bengi Yilmaz Erdemli
Förderung
- University of Health Sciences Türkiye Research Foundation
Zitieren
APA
Akbulut, M., Kalyoncuoğlu, Ü. T., & Erdemli, B. Y. (2026). Effects of low‐pressure plasma and ytterbium fiber laser on zirconia surface properties and bond strength to gingiva‐colored composite. Journal of Prosthodontics. https://doi.org/10.1111/jopr.70219
Vancouver
Akbulut M, Kalyoncuoğlu ÜT, Erdemli BY. Effects of low‐pressure plasma and ytterbium fiber laser on zirconia surface properties and bond strength to gingiva‐colored composite. Journal of Prosthodontics. 2026. doi:10.1111/jopr.70219
BibTeX
@article{Akbulut2026,
author = {Akbulut, Merve and Kalyoncuoğlu, Ülkü Tuğba and Erdemli, Bengi Yilmaz},
title = {Effects of low‐pressure plasma and ytterbium fiber laser on zirconia surface properties and bond strength to gingiva‐colored composite},
journal = {Journal of Prosthodontics},
year = {2026},
doi = {10.1111/jopr.70219}
}
EUVIMED