Effect of extrinsic pigmentation and multiple firing cycles on the properties of a zirconia‐containing lithium silicate ceramic
Journal of Prosthodontics · 2025
DOI: 10.1111/jopr.14007 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Prosthodontics, 2025. Verfasst von Everton Cocati Andrade und 7 weiteren Autor:innen. Beteiligte Einrichtung: Department of Dentistry, Centro Universitário Governador Ozanam Coelho (UNIFAGOC), Doutor Adjalme da Silva Botelho, Ubá, Brazil. Hauptthemen laut MEDLINE: Zirconium, Ceramics, Silicates, Dental Materials. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 38 Literaturangaben. Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: Coordination for the Development of Higher Education Personnel-Brazil (CAPES), NIDCR NIH HHS, U.S. National Institutes of Health.
Abstract (Originalsprache)
Purpose
To assess the impact of staining and multiple firings on the mechanical, optical, and surface characteristics of zirconia‐containing lithium silicate ceramics (ZLS). Materials and Methods Ninety ZLS discs (Suprinity, VITA Zahnfabrick) were divided according to the “Number of firings” protocol: Ctr‐control, no characterization; SC–single firing cycle (for characterization, crystallization and staining simultaneously); and DC–double firing cycle (crystallization firing cycle was performed separately from the staining firing). Extrinsic pigmentation was performed to replicate the characterization of a monolithic restoration. A layer of stain and glaze was applied with a fine brush to the ceramic surface. Specimens were fired two or four cycles, designed to simulate additional staining firings for potential characterization adjustments, but without applying new stain, resulting in six groups (n = 15): Ctr II , Ctr IV , SC II , SC IV , DC II , and DC IV . X‐ray diffraction, color, translucency, and surface roughness analysis were also performed, and the samples were subjected to the biaxial flexural strength test. Data were subjected to one‐way ANOVA, Tukey's test (α = 0.05), and Weibull analysis.
Results
No changes in the diffractogram pattern were found, irrespective of the number of firings. The translucency ( p = 0.02) and roughness ( p < 0.01) of DC IV were significantly reduced compared to DC II . DC IV also showed the highest flexural strength (325.52 A MPa), followed by SCII (271.64 B MPa).
Conclusions
Repeated firings increased the flexural strength of ZLS, where the double‐step characterization technique demonstrated better statistical results than the other groups. Moreover, despite the ceramic showing good color stability, repeated firings significantly compromised its translucency.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department of Dentistry, Centro Universitário Governador Ozanam Coelho (UNIFAGOC), Doutor Adjalme da Silva Botelho, Ubá, Brazil.
- Department of Dentistry, Federal University of Rio Grande do Norte (UFRN), Lagoa Nova, Natal, Brazil.
- Department of Dental Materials and Prosthesis, Institute of Science and Technology, Paulista State University (UNESP), São José dos Campos, SP, Brazil.
- National Institute of Spatial Researchs - INPE/LAS, Jardim da Granja, São José dos Campos, São Paulo, Brazil.
- Department of Restorative Dentistry, Federal University of Juiz de Fora, Campus Universitário, São Pedro, Brazil.
- Department of Dentistry, Federal University of Juiz de Fora, Campus Governador Valadares, Rua São Paulo, Centro, Governador Valadares, MG, Brazil.
ORCID-Profile: Everton Cocati Andrade, Sarah Emille Gomes da Silva, Taciana Marco Ferraz Caneppele, João Paulo Barros Machado, Fabíola Pessoa Pereira Leite, Jean Soares Miranda, Rodrigo Othávio de Assunção E Souza
Förderung
- Coordination for the Development of Higher Education Personnel-Brazil (CAPES)
- NIDCR NIH HHS
- U.S. National Institutes of Health
- Coordination for the Improvement of Higher Education Personnel
- National Institute of Dental and Craniofacial Research
- Coordenação de Aperfeiçoamento de Pessoal de Nível Superior
Zitieren
APA
Andrade, E. C., da Silva, S. E. G., Caneppele, T. M. F., Machado, J. P. B., Leite, F. P. P., Miranda, J. S., Zhang, Y., & E Souza, R. O. A. (2025). Effect of extrinsic pigmentation and multiple firing cycles on the properties of a zirconia‐containing lithium silicate ceramic. Journal of Prosthodontics. https://doi.org/10.1111/jopr.14007
Vancouver
Andrade EC, da Silva SEG, Caneppele TMF, Machado JPB, Leite FPP, Miranda JS, et al. Effect of extrinsic pigmentation and multiple firing cycles on the properties of a zirconia‐containing lithium silicate ceramic. Journal of Prosthodontics. 2025. doi:10.1111/jopr.14007
BibTeX
@article{Andrade2025,
author = {Andrade, Everton Cocati and da Silva, Sarah Emille Gomes and Caneppele, Taciana Marco Ferraz and Machado, João Paulo Barros and Leite, Fabíola Pessoa Pereira and Miranda, Jean Soares and Zhang, Yu and E Souza, Rodrigo Othávio de Assunção},
title = {Effect of extrinsic pigmentation and multiple firing cycles on the properties of a zirconia‐containing lithium silicate ceramic},
journal = {Journal of Prosthodontics},
year = {2025},
doi = {10.1111/jopr.14007}
}
EUVIMED