EUVIMEDEUVIMED entdecken
Crossref

The fracture strength and the failure mode of lithium disilicate or resin nano ceramics as a crown, overlay, or endocrown restoration on endodontically treated teeth

Valentin Vervack iD, Camilla Johansson, Peter De Coster, Wietske Fokkinga, Evaggelia Papia, Stefan Vandeweghe iD

Journal of Esthetic and Restorative Dentistry · 2024-05 · 36 (5) · 796-803

DOI: 10.1111/jerd.13187 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Esthetic and Restorative Dentistry, online erschienen am 28.12.2023. Verfasst von Valentin Vervack und 5 weiteren Autor:innen. Beteiligte Einrichtung: Department of Oral Health Sciences, Reconstructive Dentistry, Faculty of medicine and Health Sciences, Ghent University, Ghent, Belgium. Hauptthemen laut MEDLINE: Tooth, Nonvital, Tooth Fractures. Die Arbeit wurde bisher 16-mal zitiert (Crossref) und nennt 42 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Introduction

Different materials and restorative concepts have been proposed over the years to restore endodontically treated teeth (ETT). Monolithic ceramic and composite restoration can be lute to the tooh, without the use of a post. However, little is known how the material stiffness and presence of a composite core will affect the survival and failure mode. The objective of this in‐vitro study was to evaluate the fracture strength and failure mode of endodontically treated molars, restored with ceramic or hybrid composite monolithic restoration, in the presence of absence of a composite core. Materials and Methods Sixty depulped molars were restored with a lithium‐disilicate (e.max CAD) or hybrid composite (Cerasmart) restoration. Both materials were used in a monolithic approach, but with 3 different designs: (a) monolithic endocrown, (b) crown with a separate composite core, and (c) overlay without core buildup or pulpal extension. Ten sound teeth were used as control group. All groups were thermocycled (10,000 cycles), subsequently loaded in a chewing simulator (100,000 cycles) and finally loaded until fracture.

Results

Peak fracture loads and failure modes were registered. No significant differences were seen between the groups in terms of fracture load. Failure modes were statistically significantly different among groups with significant correlation between restoration type and material. ( p < 0.001 and p = 0.033, respectively). No group presented significantly higher fracture resistance. Although ceramic crowns and overlays presented the highest repairability, all restored ETT were within the range of the intact tooth' fracture strength.

Conclusion

No restoration presented significant different fracture loads. However, the type of restoration and material choice were correlated to the fracture mode.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Tooth, NonvitalTooth FracturesHumansFlexural StrengthDental Restoration FailureDental PorcelainCrownsCeramicsDental Stress AnalysisMaterials TestingComposite Resins

Stichwörter der Autor:innen

digital workflowendocrownfull coverage crownlithium Disilicateoverlayresin Nano ceramicshort fiber‐reinforced composite

Substanzen

lithia disilicateDental PorcelainComposite Resins

Autor:innen und Institutionen

  • Department of Oral Health Sciences, Reconstructive Dentistry, Faculty of medicine and Health Sciences, Ghent University, Ghent, Belgium.
  • Faculty of Odontology, Material Science and Technology, Dental Technology, Malmö University, Malmö, Sweden.
  • Department of Dentistry, Radboud Institute for Health Sciences, Radboud University Medical Centre, Nijmegen, The Netherlands.

ORCID-Profile: Valentin Vervack, Stefan Vandeweghe

Zitieren

APA

Vervack, V., Johansson, C., Coster, P., Fokkinga, W., Papia, E., & Vandeweghe, S. (2024). The fracture strength and the failure mode of lithium disilicate or resin nano ceramics as a crown, overlay, or endocrown restoration on endodontically treated teeth. Journal of Esthetic and Restorative Dentistry, 36(5), 796-803. https://doi.org/10.1111/jerd.13187

Vancouver

Vervack V, Johansson C, Coster P, Fokkinga W, Papia E, Vandeweghe S. The fracture strength and the failure mode of lithium disilicate or resin nano ceramics as a crown, overlay, or endocrown restoration on endodontically treated teeth. Journal of Esthetic and Restorative Dentistry. 2024;36(5):796-803. doi:10.1111/jerd.13187

BibTeX
@article{Vervack2024,
  author = {Vervack, Valentin and Johansson, Camilla and Coster, Peter De and Fokkinga, Wietske and Papia, Evaggelia and Vandeweghe, Stefan},
  title = {The fracture strength and the failure mode of lithium disilicate or resin nano ceramics as a crown, overlay, or endocrown restoration on endodontically treated teeth},
  journal = {Journal of Esthetic and Restorative Dentistry},
  year = {2024},
  volume = {36},
  number = {5},
  pages = {796--803},
  doi = {10.1111/jerd.13187}
}
Kostenlos starten →