EUVIMEDEUVIMED entdecken
Crossref

3D‐printed SiC‐microfiber‐reinforced polymer‐derived ceramic with high strength at elevated temperature

Brett G. Compton, Phuong P. Bui, Stian K. Romberg, James W. Kemp, Jesse L. Reed, Avah J. Cherry, Tobias A. Schaedler

Journal of the American Ceramic Society · 2025-12 · 108 (12)

DOI: 10.1111/jace.70143 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of the American Ceramic Society, online erschienen am 04.08.2025. Verfasst von Brett G. Compton und 6 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 51 Literaturangaben. Gefördert von: University of Tennessee, Knoxville.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this work, a polymer‐derived ceramic composite was formulated using polysilazane resin, silicon carbide microfiber reinforcement, and fumed alumina rheology modifier. Demonstration pieces and flexural test specimens were 3D printed using direct ink writing, a type of material extrusion additive manufacturing technology. Printed specimens were cured and then pyrolyzed at 1200°C in argon, resulting in 3D‐printed polymer‐derive ceramic composites. Flexural test specimens were tested in 3‐pt. flexure at room temperature and at high temperature (1200, 1400, 1500, and 1600°C). Flexural strength increased from 97.8 ± 20.1 MPa at room temperature to 367 ± 88 MPa and 401 ± 54 MPa at 1200 and 1400°C, respectively. Strength decreased to ∼184 MPa at 1500°C and was not measurable at 1600°C. Microscopy of fracture surfaces reveals evidence of degradation of the matrix phase above 1400°C and x‐ray diffraction reveals the formation of mullite above 1200°C.

Förderung

  • University of Tennessee, Knoxville

Zitieren

APA

Compton, B. G., Bui, P. P., Romberg, S. K., Kemp, J. W., Reed, J. L., Cherry, A. J., & Schaedler, T. A. (2025). 3D‐printed SiC‐microfiber‐reinforced polymer‐derived ceramic with high strength at elevated temperature. Journal of the American Ceramic Society, 108(12). https://doi.org/10.1111/jace.70143

Vancouver

Compton BG, Bui PP, Romberg SK, Kemp JW, Reed JL, Cherry AJ, et al. 3D‐printed SiC‐microfiber‐reinforced polymer‐derived ceramic with high strength at elevated temperature. Journal of the American Ceramic Society. 2025;108(12). doi:10.1111/jace.70143

BibTeX
@article{Compton2025,
  author = {Compton, Brett G. and Bui, Phuong P. and Romberg, Stian K. and Kemp, James W. and Reed, Jesse L. and Cherry, Avah J. and Schaedler, Tobias A.},
  title = {3D‐printed SiC‐microfiber‐reinforced polymer‐derived ceramic with high strength at elevated temperature},
  journal = {Journal of the American Ceramic Society},
  year = {2025},
  volume = {108},
  number = {12},
  doi = {10.1111/jace.70143}
}
Kostenlos starten →