EUVIMEDEUVIMED entdecken
Crossref

Coupling-Parameter-Based Unequal Power Divider for On-Chip Systems

Guangxu Shen, Penghan Xu, Bijing Wen, Pinhao Zhou, Wenjie Feng, Haidong Chen, Wenquan Che

IEEE Transactions on Microwave Theory and Techniques · 2025-11 · 73 (11) · 9096-9108

DOI: 10.1109/tmtt.2025.3591779 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Transactions on Microwave Theory and Techniques, 2025-11. Verfasst von Guangxu Shen und 6 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 28 Literaturangaben. Gefördert von: Fund of National Key Laboratory of Radar Detection and Sensing, National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This article proposes a new kind of unequal power divider by using coupling parameters, featuring of naturally compact size, especially in on-chip systems. In the reported unequal power dividers, the unequal ratio was usually realized by selecting different characteristic impedances of quarter-wave ( $\lambda $ /4) or quasi- $\lambda $ /4 transmission lines (TLs). However, the circuit sizes were large, which are unacceptable for on-chip systems. In addition, the bandwidths of adjacent branches mismatch since the coupling coefficients change with different characteristic impedances of $\lambda $ /4 TLs. To solve this issue, this article proposes a first-time realization of unequal power division by using the coupling parameters inside each branch of filtering power divider, including the external quality factors ( $Q_{e}$ ) and coupling coefficients ( k ). The power division ratio is analytically derived, and the divided power in each branch increases with lower characteristic impedance of input $Q_{e}$ . In addition, by adjusting multiple coupling parameters, there will be enough design freedom to realize the desired power ratio, impedance matching, and matched or unmatched bandwidth. At last, an isolated strip line is added to improve the output isolation between adjacent branches on the chip. For demonstration, a 25-GHz 1.4:1 power divider is designed using GaAs-based integrated passive device (IPD) technology. Low loss, high isolation, small chip size, and a high-selectivity filtering response are achieved in millimeter-wave range, indicating the possible application of the proposed power divider in RF chips.

Förderung

  • Fund of National Key Laboratory of Radar Detection and Sensing
  • National Natural Science Foundation of China

Zitieren

APA

Shen, G., Xu, P., Wen, B., Zhou, P., Feng, W., Chen, H., & Che, W. (2025). Coupling-Parameter-Based Unequal Power Divider for On-Chip Systems. IEEE Transactions on Microwave Theory and Techniques, 73(11), 9096-9108. https://doi.org/10.1109/tmtt.2025.3591779

Vancouver

Shen G, Xu P, Wen B, Zhou P, Feng W, Chen H, et al. Coupling-Parameter-Based Unequal Power Divider for On-Chip Systems. IEEE Transactions on Microwave Theory and Techniques. 2025;73(11):9096-9108. doi:10.1109/tmtt.2025.3591779

BibTeX
@article{Shen2025,
  author = {Shen, Guangxu and Xu, Penghan and Wen, Bijing and Zhou, Pinhao and Feng, Wenjie and Chen, Haidong and Che, Wenquan},
  title = {Coupling-Parameter-Based Unequal Power Divider for On-Chip Systems},
  journal = {IEEE Transactions on Microwave Theory and Techniques},
  year = {2025},
  volume = {73},
  number = {11},
  pages = {9096--9108},
  doi = {10.1109/tmtt.2025.3591779}
}
Kostenlos starten →